Installation Guide

23
!6-B WATER AND POWER SUPPLY CONNECTION (FOR GB & EU ONLY)
IMPORTANT!
●●
Old water fittings (hose-sets) should not be reused.
●●
The appliance includes a stainless braided water line hose.
●●
The shut off valve should be accessible.
●●
Make sure each appliance is connected to a separate power socket.
WARNING!
●●
The water connection steps below are intended only for the
professional installer.
●●
WARNING — connect to potable drinkable water supply only.
●●
DO NOT install on line pressure above 120psi (827kPa) or below 22psi (150kPa).
●●
DO NOT use on hot water supply (100°F [38°C max.]).
Water fittings kit
(Ice and Water
modelsonly)
Collet locking clip
(1)
3/4” (19mm)
BSP water fitting
(1)
1/4” (6.4mm)
plastic tubing
(1)
D
C
4 Pull the end of the plastic tube all the way to the front of the
appliance and insert 16mm into the PRV (C).
5 Secure the connection with a locking clip between the PRV
andhose end of the adaptor (D).
6 Check the connection and open the water supply to testforleaks.
Note:
– The water supply connection is applicable for freezer
models only.
– For dual installation, do the steps forboth first
andsecondappliances.
Connecting to power supply
7 At the back of your appliance, uncoil the power cord from the
clips (E) and connect to the power supply (230 VAC, 50 Hz)(F).
– You will hear a chime sound when the appliance is
powered on and automatically goes into ‘Installer
(standby) mode’.
– Refer to ‘User guide’ for more details on activating
theappliance.
Connecting to water supply (for Ice and Water models only)
1 Move the appliance in front of the cabinetry close enough that you can access
behind for power and waterconnections.
2 Attach the water fitting to one end of the plastic tube and connect it to a
water tap (A). Flush water through the water tube prior to connection to the
appliance to remove any debris in the hose.
3 Insert the other end of the tube through a hole at the rear of the plinth (B).
F
B
Rear view
ofappliance
E
A