Installation Guide

25
IMPORTANT!
●●
Ensure that the hose is not run over when moving the appliance/s to prevent damage and possible water leaks.
●●
Use low speed, low torque setting when using a powered driver.
●●
Ensure power cord is not damaged during installation.
Aligning the appliance inside the cabinetry
6 Mark the step on each alignment gauge based on the thickness
ofthe door panel to be installed to the door (B).
7 Align the marked steps of the gauges flush with the front surface
ofthe cabinetry.
– Place a ruler on the steps of the alignment gauges to check if
they are in line (C) relative to the thickness of the door panel.
8 Check if the gaps between appliance and cabinetry side walls are
even on both sides.
Positioning the appliance inside the cabinetry
1 Coil the water hose flat behind the appliance.
2 Before rolling the appliance into the cabinetry, insert a barbed plug
into a large hole on each side of the appliance to protect the inside
of the cabinetry from being damaged by screws on the sides of the
appliance(A).
3 Roll the appliance slowly into the cabinetry. Ensure that the water hose
isnot run over to prevent damage that can cause a water leak.
4 Continue rolling the appliance into the cabinetry until the anti-tip
bracket overlaps (min 180mm) the back top surface of the appliance.
Referto‘Cavity Preparation’.
5 Check the clearance between the floor and the feet. Ensure the rollers
ofthe appliance can roll freely on the floor.
C
B
C
B
A
Install fasteners kit
Barbed plug
(2)
Tools
Cross-head screwdriver
Powered driver (optional)
Ruler
Mark the step on each alignment gauge
based on the thickness of the door panel
to be installed to the door.
!7 SINGLE INSTALLATION