Installation Guide

26
5 Fix each top bracket to the ceiling surface with two 8Gx16 countersunk
screws (B).
– 457mm column = 1 bracket
– 610mm column = 2 brackets
– 762mm column = 2 brackets
Note: Make sure the appliance does not move as you open the door
when you install the screws.
6 Fix the alcove side brackets (1x per each side) to the alcove side
surface with 8Gx16 countersunk screws (C).
B B
C C
B
IMPORTANT!
●●
Make sure to remove the depth alignment brackets before fixing
the appliance inside the cabinetry.
●●
Open the appliance door to remove the alignment brackets from
both sides of the appliance, and then re-tighten the screws.
2 Continue turning the adjusting screws alternately between front and rear
feet until you achieve the correct alignment.
3 Once you are satisfied with the alignment, raise the height of the appliance
by alternately adjusting the front and rear feet until the top surface contacts
the alcove ceiling.
– Check the alignment gauges while adjusting the screws to make sure
you maintain the alignment of the appliance.
4 Ensure all feet are positively engaged with the floor.
Rear footFront foot
IMPORTANT!
●●
Ensure the doors are in line with the cabinetry front and the appliance
is centred.
●●
All four corners of the appliance must be supported firmly onto the floor
to eliminate any movement. Installing the appliance on a soft, uneven, or
not level floor may cause twisting and poor door sealing.
Tools
Cross-head screwdriver
Powered driver (optional)
A
Front foot
adjustment
Rear foot
adjustment
Adjusting height of the appliance inside the cabinetry
1 Turn the front and rear adjustment
screws using a cross-head
screwdriver (or powered driver)
to extend the feet until it engages
the floor.
– One turn of height adjusting
nuts is equivalent to 0.5mm
of height adjustment.
Clockwise turn raises the
height and counter-clockwise
turn lowers height (A).
– Align bottom gauge.
– Adjust height.
– Align top gauge.
Fixing the appliance inside the cabinetry
C
!7 SINGLE INSTALLATION