Installation Guide

27
Attaching the central spacer to cabinetry
Note: The spacer must be attached between
the first and second appliances. The attachment
location of the spacer to the alcove ceiling
depends on the model of eachappliance.
1 Measure from the alcove side towards
thecentre.
Note: The alcove width for each side depends
on the size of the appliance to be installed.
Forexample,
– left side alcove width (A) = 457mm model
– right side alcove width (B) = 762mm model
Refer to ‘Cavity dimensions’ section for dual
install options.
2 Using one depth alignment gauge, mark the
location and depth position of the central spacer
on the alcove ceiling depending on the door
panel thickness (C).
– Make sure to follow the marked depth of
the alignment gauge relative to the door
panel (D).
3 Fix the central spacer to the alcove ceiling
with two 8Gx16 countersunk screws.
Tightenthescrews with a screwdriver or
Powered driver)(E).
IMPORTANT!
●●
Dual installation applies to two appliances to be installed side by side.
●●
A joiner kit is required and located in the Freezer model only.
●●
The joiner kit is also available for purchase through an authorised
Fisher & Paykel dealer. Visit fisherpaykel.com for more information.
●●
Refer to ‘Cavity dimensions’ section for cabinetry overall width for dual
install, and ‘Dual installation option’ for selecting applicable options.
●●
We recommend to place the appliance (Freezer) with water connection
first into the cabinetry to allow you to check the connection before
placing the second appliance.
●●
Follow the steps carefully for the correct installation of first and second
appliances inside the cabinetry.
A
B
E
D
C
Install fasteners kit
Cabinet depth alignment
gauge (1)
Top joiner
bracket kit
Central spacer
(1)
#8 x 16 Mush Washer Twin Thread Philips Screw
#8 x 16 Mush Washer Twin Thread Philips Screw
8Gx16 Mush washer screw
(2)
Tools
Cross-head screwdriver
Powered driver (optional)
!8 DUAL INSTALLATION