Installation Guide

29
Positioning and aligning the first appliance inside the cabinetry
1 Coil the water hose flat behind the first appliance. (Refer to ‘Connect to
water and power supply’).
2 Before rolling the first appliance, insert a barbed plug into a large hole on
the cabinetry side of the appliance to protect the inside of the cabinetry
from being damaged by screws on the side of the appliance (A).
3 Roll the first appliance (preferably, Freezer) inside the cabinetry (B).
– Ensure that the water hose is not run over to prevent damage and
possible water leak.
4 Continue rolling the appliance into the cabinetry until the anti-tip bracket
overlaps [minimum 180mm the back top surface of the appliance.
(Refer to ‘‘Cavity Preparation’).
5 Check the clearance between the floor and the feet. Ensure the rollers
oftheappliance can roll freely on the floor.
6 Align the top cap of the first appliance flush with the front of the spacer(C).
7 Mark the step (D) of each alignment gauge based on the thickness of the
door panel to be installed to the door.
8 Align the marked steps of the gauges flush with the front surface of
thecabinetry.
– Place a ruler on the steps of the alignment gauges to check if they
arein line (E) relative to the thickness of the door panel.
9 Check if the gaps between appliance and cabinetry side wall are even.
IMPORTANT!
●●
Make sure that all feet engage the floor and evenly support the appliance.
●●
Tighten the adjustment screw with screwdriver (do not use powered driver).
Note: The appliance can be rolled first into the left side or right side
of the cabinetry depending on your preference.
B
A
Install fasteners kit
Barbed plug
(2)
Tools
Ruler
E
D
C
!8 DUAL INSTALLATION