Installation Guide

30
IMPORTANT!
●●
Ensure the doors are in line with the cabinetry front and the appliance is centred.
●●
All four corners of the appliance must be supported firmly onto the floor to eliminate any movement.
●●
Installing the appliance on a soft, uneven, or not level floor may cause twisting and poor door sealing.
Fixing the first appliance inside the cabinetry
5 Fix each top bracket of first appliance to ceiling surface with two (2x)
8Gx16 countersunk screws (B).
– 457mm column = 1 bracket
– 610mm column = 2 brackets
– 762mm column = 2 brackets
Note: Ensure the appliance does not move as you open the door when
you install the screws.
6 Fix the alcove side bracket to alcove side surface with one 8Gx16
countersunk screw (C).
Note: Image shows 457mm (first appliance) with 1 top bracket.
B
C
Alcove side bracket
C
B
2 Continue turning the adjusting screws alternately between front
and rear feet until you achieve the correct alignment.
3 Once you are satisfied with the alignment, raise the height of the
appliance by alternately adjusting the front and rear feet until the
top surface contacts the alcove ceiling.
– Check the alignment gauges while adjusting the screws to
make sure you maintain the alignment of the appliance.
4 Ensure all feet are positively engaged with the floor.
Rear footFront foot
A
Front foot
adjustment
Rear foot
adjustment
1 Turn the front and rear adjustment
screws using a cross-head
screwdriver (or powered driver)
to extend the feet until it engages
the floor.
– One turn of height adjusting
nuts is equivalent to 0.5mm
of height adjustment.
Turnclockwise to raise the
height and counter-clockwise
to lower height (A).
Adjusting height of the appliance inside the cabinetry
Install fasteners kit
#8 x 19 Countersunk Twin Thread Posi Screw
#8 x 19 Countersunk Twin Thread Posi Screw
8Gx16 Countersunk screw
(5)
Tools
Cross-head screwdriver
Powered driver (optional)
!8 DUAL INSTALLATION