Installation Guide

36
Tools
Cross-head screwdriver
Powered driver
(with 2.5mm drill bit)
M4 hex key
(1)
13mm spanner
(1)
Hang the door panel
1 Remove the gauges and retighten the screws.
Openthedoor and loosen the screws at both sides
ofthedoor (donot remove) (A).
2 Hang the door panel with a small angle to the door by
locating the holes of the top bracket to the M8 studs (B),
and rotate the door panel down so that the side attachment
brackets slide onto the side screws of the door. (C)
3 Screw the M8 washer and nut to the stud (D), and
re-tighten the side screws (A) to fix the door panel
(donotfully tighten). This will allow opening the door
without affecting adjustment of the door panel.
Note:
We recommended to load the shelves in the appliance door
with weights to ensure an accurate door panel gap width.
Weight recommendations:
– 457mm appliance: 10kg
– 610mm appliance: 15kg
– 762mm appliance: 20kg
Adjust the door panel
Note: Check the gaps between door panel/cabinetry using
the gauge (3mm). All door panels have full axis adjustment
to ensure they are flush with adjacent walls.
1 To adjust the height of the door panel relative to the door,
use M4 hex key to turn the top M8 screw (E) clockwise to
lower or counter-clockwise to raise the door panel until
thegap with the cabinetry above is 3mm.
2 To adjust the depth of the door panel, loosen the side
screws (F) from each side and slide the panel forward/
backward. Re-tighten once satisfied.
3 To adjust the door panels further, remove the door panels
then loosen the fixing screws for the hanging bracket
andmove the bracket sideways to suit. (G)
4 Once satisfied with the door panel position, fully tighten
M8washer and nut to the stud using the supplied hex key
and spanner (E).
Fix the locking brackets
1 Loosen the screw at the bottom of the door, and slide
thelocking bracket out until it touches the panel (H).
2 Fix the locking bracket to the door panel with 8Gx16
countersunk screw (I).
3 Re-tighten the screw at the bottom of door (J).
C
A
D
B
G
F
E
J
I
H
@0 DOOR PANEL INSTALLATION (STAINLESS STEEL)