Installation Guide

37
IMPORTANT!
●●
Ensure the screw pilot holes do not penetrate the full depth of the panel.
●●
Do not place the handle holes in marked areas to avoid clashing with panel attachment brackets.
●●
Minimum panel thickness where screw hole is drilled must be 16mm.
Remove hanging bracket
1 Remove the M8 washer and M8 nut fromthe
M8 screws at the top the door (A) using the
supplied hex key and spanner.
Attach the door handle
5 Fix the handle with M5x25 hex screws from the inner
edge of the panel (D). Refer to ‘Custom door panel
dimensions’ section to ensure door handle does not
interfere with side attachment brackets.
Attach the hanging and side brackets
6 Mark the centreline from the top of the Custom
panel and align with the ‘V’ notch in the bracket (E).
7 Align the screw holes of the bracket with the screw
holes of the door panel and fix the hanging bracket
to the door panel with M5x12 Cross-head screws (F).
– 6 screws for 457mm
– 10 screws for 610mm and 762mm
8 Align the side panel bracket assembly (bracket,
slider and spacer) to the screw holes on the side
of the door panel and fix with 8Gx16 mush washer
screws (G).
D
B
2 Remove the M8 washer and M8
nut fromthe M8 screws at the top
the door (B).
3 Unscrew the adjustment screws
by3mm to move close to the
middle of adjustment range (C).
4 Mark the location of the screw
holes and drill pilot holes to the
marked location.
Refer to the custom panel
template in the ‘Custom door
panel dimensions’ section.
F
G
G
E
Door handle kit
M5 x 25 Pan Head Socket Screw OR M5x25 hex screw
M5 x 25 Pan Head Socket Screw OR M5x25 hex screw
M5x25 Hex screw
(4x)
Door panel
attachment kit
Side bracket
(6)
Bracket slider
(6)
Bracket spacer
(6)
#8 x 16 Mush Washer Twin Thread Philips Screw
#8 x 16 Mush Washer Twin Thread Philips Screw
M5x12 Cross-head screw
(30)
Tools
Powered driver
(with 2.5mm drill bit)
M4 hex key
(1)
13mm spanner (1)
A
3mm
C
@1 DOOR PANEL INSTALLATION (CUSTOM)