Installation Guide
Table Of Contents
- 1 Safety and warnings
- 2 Integrated columns
- 3 Components
- 4 tools
- 5 dual install options
- 6 appliance dimensions and specifications
- 7 Cabinetry options
- 8 Cavity dimensions
- 9 Door and toe kick panel dimensions
- !0 Custom door panel dimensions
- !1 Door clearance
- !2 Electrical and plumbing dimensions
- !3-A Electrical and plumbing specifications (FOR NZ & AU only)
- !3-b Electrical and plumbing specifications (for GB & EU only)
- !4 Before installation
- !5 cavity preparation
- !6-A water and power supply connection (For NZ & AU only)
- !6-b water and power supply connection (For GB & EU only)
- !7 Single installation
- !8 Dual installation
- !9 water filter InstallATION
- @0 door panel installation (Stainless steel)
- @1 door panel installation (Custom)
- @2 toe kick installation
- @3 cabinet trims Installation
- @4 door trims installation
- @5 Optional — Changing over door hinges
- @6 Final checklist
38
Tools
Cross-head screwdriver
Powered driver/drill
(with 2.5mm bit)
M4 Hex key
(1)
13mm spanner
(1)
Hang the door panel
1 Remove the gauges and retighten the screws. Open the door and
loosen the screws at both sides of the door (do not remove) (A).
2 Hang the door panel with a small angle to the door by locating
theholes of the top bracket to the M8 studs (B), and rotate the
door panel down so that the side attachment brackets slide onto
the side screws of the door. (C)
3 Screw the M8 washer and nut to the stud (D), and re-tighten the side
screws (A) to fix the door panel (do not fully tighten). This will allow
opening the door without affecting adjustment of the door panel.
Note: We recommended to load the shelves in the appliance door
with weights to ensure an accurate door panel gap width.
Weight recommendations:
– 457mm appliance: 10kg
– 610mm appliance: 15kg
– 762mm appliance: 20kg
Adjust the door panel
Note: Check the gaps between door panel/cabinetry using
the gauge (3mm). All door panels have full axis adjustment to
ensurethey are flush with adjacent walls.
1 To adjust the height of the door panel relative to the door, use
M4 hex key to turn the top M8 screw (E) clockwise to lower or
counter-clockwise to raise the door panel until the gap with the
cabinetry above is 3mm.
2 To adjust the depth of the door panel, loosen the side
screws (F) from each side and slide the panel forward/backward.
Re-tighten once satisfied.
3 To adjust the door panels further, remove the door panels then
loosen the fixing screws for the hanging bracket and move the
bracket sideways to suit. (G)
4 Once satisfied with the door panel position, fully tighten
M8washer and nut to the stud using a M4 hex key (E).
Fix the locking brackets
1 Loosen the screw at the bottom of the door, and slide the
lockingbracket out until it touches the panel (H).
2 Fix the locking bracket to the door panel with 8Gx16
countersunkscrew (I).
3 Re-tighten the screw at the bottom of door (J).
IMPORTANT!
●●
If using Custom door panels, ensure they are prepared as per ‘Custom door panel dimensions’ section.
C
A
D
B
G
F
E
J
I
H
@1 DOOR PANEL INSTALLATION (CUSTOM)