Installation Guide
Table Of Contents
- 1 Safety and warnings
- 2 Integrated columns
- 3 Components
- 4 tools
- 5 dual install options
- 6 appliance dimensions and specifications
- 7 Cabinetry options
- 8 Cavity dimensions
- 9 Door and toe kick panel dimensions
- !0 Custom door panel dimensions
- !1 Door clearance
- !2 Electrical and plumbing dimensions
- !3-A Electrical and plumbing specifications (FOR NZ & AU only)
- !3-b Electrical and plumbing specifications (for GB & EU only)
- !4 Before installation
- !5 cavity preparation
- !6-A water and power supply connection (For NZ & AU only)
- !6-b water and power supply connection (For GB & EU only)
- !7 Single installation
- !8 Dual installation
- !9 water filter InstallATION
- @0 door panel installation (Stainless steel)
- @1 door panel installation (Custom)
- @2 toe kick installation
- @3 cabinet trims Installation
- @4 door trims installation
- @5 Optional — Changing over door hinges
- @6 Final checklist
42
Reinstall the top trim
1 Slide the top trim into hinge pocket of the cabinet (A),
and then engage the dual lock at the non-hinge side (B).
B
A
Install the centre trims (for Dual install only)
Note: Four (4) dual-lock strips are pre-installed along the centre trim.
2 Position the trim between the throats
of both cabinets (D).
3 Push and press the trim on the
appliances/throat (E).
Note: Make sure the top end of the
trim is pushed up against the alcove
ceiling before fixing the position.
1 Peel off the liners from
the dual-lock strips (C).
4 Press the centre trim to fix the
position (F).
C
D
E
F
Dual install
joiner kit
Centre trim
(1)
Dual-lock strip
(4)
@3 CABINET TRIMS INSTALLATION