Installation Guide

43
IMPORTANT!
The door flow divider is pre-assembled to the door of the appliance. It blocks the air flow from bypassing in front of the bottom grille.
Expose adhesive Exploded with machine screw
Twist to prise open
Cut airflow divider for 6” toekick
E
Note:
When fitting the air flow divider to the door
for a toe kick height greater than 102mm,
the divider requires shortening. Cutalong
the outline on both the divider and divider
cover (E) before installation to the door.
Ensure to file the cut portions of the divider
and cover.
5 Attach the flow divider cap to the
flow divider (D).
B
C
D
A
Install the door trims
1 Reinstall the door panel top extrusion to the
top of the door.
– Align the notch (F) of the extrusion with
the magnet housing at the top of door (G).
– Clip the trim caps (H) at both ends of
the extrusion to the top of the door.
– Press the top door panel extrusion down
into the top of the door (I) so that the
dual lock strips engage together.
2 Press the door panel side extrusion (J) into the gap between the
door and door panel. Align the top of the door panel side extrusion
with the top door panel extrusion. Do on each side.
J
J
J
J
I
I
H
F
G
H
Miscellaneous
components
Flow divider cap
(1)
Door panel side extrusion
(2)
Tools
Hacksaw
ReInstall the flow divider
1 Peel the adhesive layer off the flow divider (A).
2 Remove the 8Gx16 countersunk screw from the bottom
of the door and re-install the flow divider using the same
screw. (Do not tighten fully) (B).
3 Press the flow divider firmly against the door panel (C).
Make sure the adhesive layer contacts the door panel.
4 Re-tighten the screw fully.
@4 DOOR TRIMS INSTALLATION