Installation Guide
Table Of Contents
- 1 Safety and warnings
- 2 Integrated columns
- 3 Components
- 4 tools
- 5 dual install options
- 6 appliance dimensions and specifications
- 7 Cabinetry options
- 8 Cavity dimensions
- 9 Door and toe kick panel dimensions
- !0 Custom door panel dimensions
- !1 Door clearance
- !2 Electrical and plumbing dimensions
- !3-A Electrical and plumbing specifications (FOR NZ & AU only)
- !3-b Electrical and plumbing specifications (for GB & EU only)
- !4 Before installation
- !5 cavity preparation
- !6-A water and power supply connection (For NZ & AU only)
- !6-b water and power supply connection (For GB & EU only)
- !7 Single installation
- !8 Dual installation
- !9 water filter InstallATION
- @0 door panel installation (Stainless steel)
- @1 door panel installation (Custom)
- @2 toe kick installation
- @3 cabinet trims Installation
- @4 door trims installation
- @5 Optional — Changing over door hinges
- @6 Final checklist
46
Moving the sensor housing
(RS46 & RS61 only)
1 Unclip the reed switch from the housing (A).
2 Unhook the interceptor board harness from
sensor housing so harness is loose (B).
3 Remove the #8x16 screws (2x) from the sensor
housing (C).
5 Reinstall the sensor housing using #8x16 screws
(2x) into the pre-drilled holes in the cabinet top
panel (E).
6 Clip the reed switch into the sensor housing in the
pocket closest to the centreline of the cabinet (F).
7 Press the harness from the interceptor board into
the forks on the sensor housing (G).
4 Move the sensor housing so that the
opposite reed switch clip is aligned with
the centre of the cabinet (D).
A
B
C
D
G
E
F
Tools
T2 star-head screwdriver
Flat-head screwdriver
@5 OPTIONAL — CHANGING OVER DOOR HINGES