Installation Guide
Table Of Contents
- Safety and warnings
- Integrated column models
- Check your appliance
- Remove pre-installed parts
- Moving your appliance
- Supplied parts
- Required parts
- Door panel set
- Door and drawer handle kits
- Hinge change kit
- Product dimensions — 610MM model
- Cavity dimensions — 610MM model
- Door panel dimensions — 610MM model
- Custom door panel install dimensions — 610MM model
- Door clearance — 610MM model
- Drawer clearance — 610MM model
- Toe kick dimensions — 610MM model
- Toe kick install options
- Product dimensions — 760MM model
- Cavity dimensions — 760MM model
- Door panel dimensions — 760MM model
- Custom door panel install dimensions — 760MM model
- Door clearance — 760MM model
- Drawer clearance — 760MM model
- Toe kick dimensions — 760MM model
- Dual install options
- Cavity dimensions — 610MM + 610MM dual install
- Cavity dimensions — 610MM + 760MM dual install
- Cavity dimensions — 760MM + 760MM dual install
- Toe kick panel dimensions — dual install
- Power supply dimensions
- Electrical specification
- Plumbing specification
- Before installation
- Install anti-tip bracket
- Connect water and power supply
- Position and alignment in cabinetry
- Secure appliance to cabinetry
- Remove hanging brackets
- Install door and drawer panels
- Install locking bracket
- Install adjustment brackets
- Install toe kick panel
- Install toe kick grilles
- Install top trim
- Install water filter
- Install air flow divider
- Install cabinet side trims
- Install door and drawer side trims
- Dual installation
- Change the door hinges (optional)
- Final checklist
51
INSTALL ADJUSTMENT BRACKETS
1 Loosen the screw at the bottom
of the refrigerator door, and slide
thelocking bracket (A) out until it
touches the panel.
2 Fix the locking bracket
to the door panel with
8Gx16 countersunk screw (B).
3 Re-tighten the screw at the
bottom of the door.
1 Loosen the cap screws (C) of the
adjustment brackets (D) on both
sides of the plinth with a hex key.
Tools
Cross-head
screwdriver
Cutter
M4 hex key (1)
13mm spanner (1)
2 Adjust the brackets to the
desired depth by moving it
forward/backward.
3 Re-tighten the cap screws
once satisfied.
INSTALL LOCKING BRACKET
A
B
C
D