Installation Guide
Table Of Contents
- 1 Safety and warnings
- 2 Components
- 4 Appliance and cavity dimensions
- 5 Cabinetry options
- 6 Door panel dimensions
- 7 Custom door panel installation dimensions
- 8 Custom door panel installation template
- 9 Door clearance
- 10 Electrical and plumbing
- 11 Before installation
- 12 Cavity preparation
- 13 Water supply connection
- 14 Power supply connection
- 15 Installation preparation
- 16 Positioning into cabinetry
- 17 Aligning inside cabinetry
- 18 Door panel installation - stainless steel
- 19 Door panel installation - custom
- 20 Fixing to cabinetry
- 21 Water filter installation
- 22 Toe kick installation
- 23 Covers and trims installation
- 24 Final checklist
17
!1 BEFORE INSTALLATION
IMPORTANT!
●
Your appliance is fitted with front and rear rollers designed for moving the appliance
forward and backward. Donot move the appliance sideways as this may damage the
rollers or the floor covering / surface.
●
The appliance must be installed by a qualified installer, or Fisher & Paykel trained and
supported service technician to avoid faulty electrical connection and water leaks.
●
All connections for water, electrical power and grounding must comply with local codes
and ordinances and be made by licensed personnel when required.
●
Avoid installation of the appliance/s under a ground fault circuit interrupter (GFCI).
●
Ensure the appliance is installed properly. Improper installation that results in appliance
failure is not covered under the appliance warranty.
Check installation location
1
Check the cabinetry
– Check the dimensions — height, width, depth, floor level,
finishedalcovereturns.
– Ensure that the ventilation openings in the cabinetry are clear of obstruction.
– For integrated installation, a finished return of solid material is required
across thetopand sides of the new or existing alcove.
– Refer to the ‘Appliance and cavity Dimensions’ (page 7) prior to installation
of the appliance.
2
Check the power supply
– Ensure that there is a separate power outlet for the appliance.
– Avoid sharing the power point with other appliances to prevent the
appliancefromaccidentally switching off.
– For power requirements, refer to the information on the serial plate.
Thisislocated atthe front right-hand side of the drawer when open.
– Ensure your appliance is properly grounded (earthed).
– Connect the appliance to the electrical supply (230 VAC, 50 Hz) with fitted
plug andlead.
– We recommend to use an isolating switch that is easily accessible to
theuserafterthe appliance is installed.
– Follow the National Electrical Code and all local codes and ordinances
wheninstallingthis appliance.
3
Check the water supply (for Ice and Water models only)
– Ensure that there is a separate water supply connection for the appliance.
– Your appliance must be installed by a qualified appliance installer as
incorrect plumbingcanlead to water leaks.
– Fisher & Paykel is not liable for damage (including water damage) caused
byfaultyinstallation or plumbing.