Installation Guide

22
!6 POSITIONING INTO CABINETRY
Position the appliance into the cabinetry
1
Ensure the power cord are secured to the clip at the back of the
appliance (A) and the excess water hose coiled flat behind the
appliance.
2
Push the appliance into the cabinetry until the anti-tip bracket
overlaps the rear top edge of the appliance (B).
– Ensure the appliance is centered.
– Ensure there is firm contact between the appliance and anti-tip
bracket withamin.60mm overlap (C).
IMPORTANT!
When positioning the appliance in the cabinetry, ensure that the
anti-tip bracket overlaps the appliance by a minimum 60mm for
asecure hold.
B
A
IMPORTANT!
●
Your appliance is fitted with front and rear rollers designed for moving the appliance in the
forwards and backwards direction.
●
Avoid moving the appliance in a sideways direction as this may damage the rollers or the
floor covering/surface.
●
Ensure the hose is not run over by the appliance when pushing into the cabinetry to
prevent damage and possible water leaks.
●
Ensure water tubing is routed away from any sharp objects, sharp corners (beware of
kinking the tube as this will stop water flow), and not in a location where it can be kinked
or squashed.
Refer to 'Attach anti-tip bracket' (page18) for more information.
Anti-tip
bracket
Min. 60mm
overlap