Top Loader Washing Machine, 10kg
Table Of Contents
- Contents
- Safety and warnings
- Installation instructions
- Before your first wash
- Safety features
- Control panel
- Wash cycles
- Eco Active™ wash
- Wash preparation
- Getting started quickly
- Wash options
- Customising a wash cycle
- Changing pre-set options
- Caring for your washer
- Before you call for service
- Fault codes
- Troubleshooting
- Manufacturer’s warranty
- Customer care
45
FAULT CODES
When a continuous series of beeps is sounded, all the lights turn off on the control panel
and a number appears on the display, a fault has occurred. The washer will automatically
enter this mode if a fault occurs. The fault code will be displayed as followed by
a number on the digital display. To stop the sound, touch any button and perform the
following steps:
1 Turn your machine off at the power point.
2 Wait 1minute and turn it back on.
3 Check your machine is correctly levelled.
4 Remove your wash load.
5 Perform a ‘Rinse’ cycle.
6 If the fault re-occurs repeat steps
1
and
2
.
7 If the machine will still not work you will be required to call a Fisher & Paykel Authorised
Repairer to arrange service (refer to the ‘Customer care’ section). Record the fault code
number displayed and the serial number of your washer (located on the rear of the
machine) before calling. The fault code will indicate to the repairer what the problem
could potentially be.
If a fault code is being displayed, you can still turn your washer off by pressing
.