Top Loader Washing Machine, 10kg

INSTALLATION INSTRUCTIONS
9
Water supply
Inlet hoses
Failure to adhere to the following instructions may result in a flood and
damage to property:
Only use the new hose set provided with your washer
Water supply requirements:
z
If you have an uncontrolled water heating source (eg a wet back or solar heating
system) you should fit a tempering valve. This will ensure the hot water temperature
remains within safe limits. Contact your registered plumber to select and install the
tempering valve.
z
Your cold water should not exceed 35°C and your hot water should not exceed
65°C. Temperatures above these may cause the machine to fault or cause damage
to the machine.
z
Inlet water static pressure: Max.1MPa(145psi) Min.34KPa (5psi).
z
Inlet water flow rate at tap: Min.8litres/min.
Cold supply only:
If you only have a cold water supply, an inlet valve cap (blanking cap) MUST be connected
to the Hot inlet valve. The cap prevents water leaking out of the hot valve. The cap is
available from your Fisher & Paykel trained and supported service technician, Part No.
388491P. This appliance incorporates backflow protection complying with AS3500.1. No
further backflow protection is required for connection to the water supply.
Note: Your washer does not have an internal heater to heat water.
Elbow
(Machine) end
Straight
(Tap) end
Inlet hose ends
1 Connect the straight ends of the inlet hoses to the taps
(thereare washers fitted in both ends). Connect the red
connector hose to Hot, and the white connector hose
to Cold.
2 Connect the elbow ends of the inlet hoses to the
corresponding machine inlet valves. Inlet valves are
marked on the back of the machine. Ensure the Hot
valve is connected to the hot tap and the Cold valve is
connected to the cold tap.
H = Hot C = Cold