User Manual

7
INSTALLATION INSTRUCTIONS
Electrical
This appliance must be supplied with a 220–240V, 50Hz, sinusoidal, 10Aelectrical
supply.
Draining

Regularly check that your standpipe or tub is free from lint or other obstructions, which
may affect how your machine works or may cause flooding.

In multi-storey apartments or any upper floor, the machine should be installed on a floor
equipped with a drain.

Draining must comply with local by-laws.
Water supply

Your cold water should not exceed 35°C and your hot water should not exceed 65°C.
Temperatures above these may cause the machine to fault or cause damage to the
machine.

If you have an uncontrolled water heating source (eg a wet back or solar heating
system) you should fit a Safe Valve. This will ensure the hot water temperature remains
within safe limits.

Inlet water static pressure: Max.1MPa(150psi) Min.34KPa (5psi)

Inlet water flow rate at tap: Min.6litres/min
HOT ‘N’ SAFE VALVES AVAILABLE ARE:
RMC TVA 50HF
RMC TVA 75HFS
Adjustable between 35°C–55°C
RMC TVA 50HP
For instantaneous gas hot water supply