Installation Guide
Table Of Contents
- Contents
- Safety and warnings
- Installation instructions
- Before your first wash
- Safety features
- Control panel
- Wash cycles
- Eco Active™ wash
- Wash preparation
- Getting started quickly
- Wash options
- Customising a wash cycle
- Changing pre-set options
- Caring for your washer
- Before you call for service
- Fault codes
- Troubleshooting
- Manufacturer’s warranty
- Customer care
INSTALLATION INSTRUCTIONS
11
Completing your installation
z
Turn on the water and check all hose connections for leaks. Make sure there are no kinks
in the hoses. Check the hose connections for leaks again after 24hours.
z
Uncoil power cord, remove and discard the plastic pin cover, and plug into wall socket.
z
Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
Installation test cycle
Your washer must be correctly installed before use. Check the installation and operation of
the washer using the following procedure:
If there are any problems, you must address these before proceeding with normal use. The
washer will automatically turn off at the end of the cycle if there are no problems.
1
Touch to activate your washer.
3
Touch to start the installation test cycle.
The display will show .
The washer will beep to signal the end of
the installation test cycle. Any faults will be
displayed on the screen (refer to the back of
this user guide to help identify faults).
If you need further assistance, please contact a Fisher&Paykel trained and supported
service technician or our Customer Care Centre. Refer to ‘Customer care’ section for
contact details.
2
Touch both and OPTIONS together for 3
seconds.
+