Installation Guide
Table Of Contents
- Contents
- Safety and warnings
- Installation instructions
- Before your first wash
- Safety features
- Control panel
- Wash cycles
- Eco Active™ wash
- Wash preparation
- Getting started quickly
- Wash options
- Customising a wash cycle
- Changing pre-set options
- Caring for your washer
- Before you call for service
- Fault codes
- Troubleshooting
- Manufacturer’s warranty
- Customer care
15
CONTROL PANEL
Keylock
Keylock can be used to lock the buttons on your FabricSmart™ washer when not in use. This
will avoid accidental button pushes from items left on the lid of the washer and also from
any little fingers.
Time to go
Your FabricSmart™ washer will display how many minutes a wash cycle has remaining, so
that you can tell at a glance when your washing will be finished. Once you have selected
your wash cycle and options, the time the wash cycle will take to complete willbe
displayed. Please be aware that actual cycle times may vary as they are influenced by a
number of factors, eg the flow rate of your water supply, the load sizeand cycle selection.
To turn your washer on, touch for 2
seconds. This will activate the display panel.
KEYLOCK will remain activated but let you
select your wash cycle options and start the
cycle.
To pause or stop your washer at any time
during the cycle, touch
for 2seconds, or
touch twice in quick succession.
Touch for 2 seconds.
When activated, the light above the
button
is illuminated.
To turn Keylock ON or OFF:
If Keylock is ON:
1
1
2