Installation Guide
Table Of Contents
- Contents
- Safety and warnings
- Installation instructions
- Before your first wash
- Safety features
- Control panel
- Wash cycles
- Eco Activeâ„¢ wash
- Wash preparation
- Getting started quickly
- Wash options
- Customising a wash cycle
- Changing pre-set options
- Caring for your washer
- Before you call for service
- Fault codes
- Troubleshooting
- Manufacturer’s warranty
- Customer care
34
CHANGING PRE-SET OPTIONS
Out of balance recovery routine
When your washer is spinning it can sense if the wash load is out of balance. If an out of
balance load is detected, the washer will stop and re-try spinning one more time. If it still
senses an unbalanced load there are two options the washer can take.
Automatic recovery OFF (default setting)
Your washer will stop, beep, and show
in three phases on the display
screen. You must redistribute the load more evenly yourself. Use this option if you wish to
conserve water.
Automatic recovery ON
Your washer will try to automatically correct the out of balance load. It will fill with water
and agitate to redistribute the load before trying to spin up again.
To change the out of balance (OOB) recovery routine:
1
Wash Temp
OOB Recovery
Factory Reset
EOC Beeps
OOB Recovery
Enter Option Adjustment mode
(refer to the OPTION ADJUSTMENT MODE
for instructions).
Select the
DELICATE cycle.
2
Wash Temp
OOB Recovery
Factory Reset
EOC Beeps
OOB Recovery
Touch the MORE or LESS button to turn
automatic recovery or .