Installation Guide
Table Of Contents
- Contents
- Safety and warnings
- Installation instructions
- Before your first wash
- Safety features
- Control panel
- Wash cycles
- Eco Active™ wash
- Wash preparation
- Getting started quickly
- Wash options
- Customising a wash cycle
- Changing pre-set options
- Caring for your washer
- Before you call for service
- Fault codes
- Troubleshooting
- Manufacturer’s warranty
- Customer care
35
CHANGING PRE-SET OPTIONS
Remember, to save changes and exit from
the Option Adjustment mode (ie to return
to normal operating mode), touch the
button.
End of cycle beeps
The beeps signalling the end of the cycle can be increased or decreased. The default
setting is 5beeps.
To modify the number of beeps sounding at the end of the cycle:
1
Wash Temp
OOB Recovery
Factory Reset
EOC Beeps
Enter Option Adjustment mode
(refer to the OPTION ADJUSTMENT MODE
for instructions).
Select the
WOOL cycle.
2
Wash Temp
OOB Recovery
Factory Reset
EOC Beeps
Touch the MORE or LESS button to
increase or decrease the number of beeps, or
for no beeps to sound at the end of the cycle.