Installation Guide

40
BEFORE YOU CALL FOR SERVICE
PROBLEM DISPLAYED AS WHAT TO DO
The washer is
not getting any
hot water.
Hot water supply is not hot enough to maintain the wash
temperature you have selected. Select a lower wash temperature.
Inlet hose filters may be blocked and should be cleaned
or replaced.
There may be a kink in the hose. Undo the hose to remove the
kink, and reattach. Damaged hoses should be replaced.
Ensure hot tap has been turned on.
Check inlet hoses are connected to the correct taps.
The washer is
not getting any
cold water.
Ensure cold tap has been turned on.
Inlet hose filters may be blocked and should be cleaned
or replaced.
There may be a kink in the hose. Undo the hose to remove the
kink, and reattach. Damaged hoses should be replaced.
Check inlet hoses are connected to the correct taps.
Cold water temperature exceeds recommended limits (refer to
‘Water supply’).
The flow rate of the supply water is too slow. Refer to a
registered plumber for advice.
The washer
is not getting
any water.
Ensure taps have been turned on.
Inlet hose filters may be blocked and should be cleaned
or replaced.
There may be a kink in the hose. Undo the hose to remove the
kink, and reattach. Damaged hoses should be replaced.
The drain hose is too low or the drain hose is pushed into the
standpipe too far and the water is siphoning out of the washer
(refer to ‘Draining’).
The flow rate of the supply water is too slow. Refer to a
registered plumber for advice.
User warnings
Your washer is capable of self diagnosis and may sound a series of beeps and display
anotification or warning to inform you when there is aproblem. In most cases you will be
able to address the problem the washer is alerting you to. Check this chart before you call
for service.