Installation Guide
Table Of Contents
- Contents
- Safety and warnings
- Installation instructions
- Before your first wash
- Safety features
- Control panel
- Wash cycles
- Eco Active™ wash
- Wash preparation
- Getting started quickly
- Wash options
- Customising a wash cycle
- Changing pre-set options
- Caring for your washer
- Before you call for service
- Fault codes
- Troubleshooting
- Manufacturer’s warranty
- Customer care
42
FAULT CODES
When a continuous series of beeps is sounded, all the lights turn off on the control panel
and a number appears on the display, a fault has occurred.
The washer will automatically enter this mode if a fault occurs. The fault code will be
displayed as a number on the digital display. To stop the sound, touch any button and
perform the following steps:
1 Turn your washer off at the power point.
2 Wait 1minute and turn it back on.
3 Remove your wash load.
4 Perform a
RINSE cycle.
5 If the washer will still not work you will be required to call a Fisher & Paykel trained and
supported service technician to arrange service (refer to the ‘Customer care’ section).
Record the fault code number displayed and the serial number of your washer (located
on the rear of the washer) before calling. The fault code will indicate to the repairer
what the problem could potentially be.
If a fault code is being displayed, you can still turn your washer off by touching
.