Installation Guide
Table Of Contents
- Contents
- Safety and warnings
- Installation instructions
- Before your first wash
- Safety features
- Control panel
- Wash cycles
- Eco Active™ wash
- Wash preparation
- Getting started quickly
- Wash options
- Customising a wash cycle
- Changing pre-set options
- Caring for your washer
- Before you call for service
- Fault codes
- Troubleshooting
- Manufacturer’s warranty
- Customer care
45
TROUBLESHOOTING
Wash problems
PROBLEM POSSIBLE CAUSES WHAT TO DO
Wash cycle time
longer than usual.
If water pressure is low, cycle
time will increase due to longer
fill times.
Ensure that inlet hose filters are
not blocked.
The out of balance automatic
recovery setting may be selected
(ie Automatic Recovery is ON).
Refer to ‘Changing pre-set options’.
Wash cycle time is approximate
and may be affected by a
number of factors.
Refer to ‘Wash cycles’.
Small amount of
water in bowl at end
of cycle.
A small amount of water may
discharge from the fill nozzle
after wash.
This is normal.
Creasing. Overloading of the washer. Try reducing load size.
Inappropriate cycle selection. Choose
EASY IRON or DELICATE cycle
as these cycles have been designed to
minimise creasing.
Spin speed too high. Try selecting a lower spin speed.
Wash temperature too high
for items.
Try selecting a lower wash temperature.
Sort your load so that items of similar
weight are washed together.
Other. Sort your load so that items of similar
weight are washed together.
Do not leave wet clothes to sit in the
washer or laundry basket.