Installation Guide
Table Of Contents
- Contents
- Safety and warnings
- Installation instructions
- Before your first wash
- Safety features
- Control panel
- Wash cycles
- Eco Active™ wash
- Wash preparation
- Getting started quickly
- Wash options
- Customising a wash cycle
- Changing pre-set options
- Caring for your washer
- Before you call for service
- Fault codes
- Troubleshooting
- Manufacturer’s warranty
- Customer care
INSTALLATION INSTRUCTIONS
6
INSTALLATION INSTRUCTIONS
Accessories
Check if you received the following accessories with your Fisher&Paykel washer. Youwill
find them inside the drum or attached to the packaging.
z
2 x inlet hose(s)
z
1 x hose guide
Unpacking
To ensure the best performance from your new washer please follow the instructions below.
Ensure that the base packer has been removed before operating your machine.
1 Remove the outer packaging.
2 Tilt the washer backwards and walk it off the base
packer one foot at a time (ensure the lid is still
taped down).
3 Remove the base packer from under the washer by
tilting the washer backwards and pulling the packer
out the front.
4 Remove the tape, lift the lid and remove the bowl
packer from the bowl.
5 Remove the hoses and accessories.
6 Keep the base packer and bowl packer in case they
are required for future transit.
Removing the packaging