WARMING DRAWER MINIMAL WB24SDEB2 & WB30SDEB1 CONTEMPORARY WB24SDEX2 & WB30SDEX1 PROFESSIONAL WB30SPEX1 INTEGRATED WB30SDEI1 USER GUIDE US CA
CONTENTS Safety and warnings 4 Before you begin 8 Using your Warming Drawer 10 Functions 11 Delayed Start 13 Sabbath mode 14 Loading your appliance 15 Using the wire shelf 17 Cooking charts 18 Care and troubleshooting Service and warranty 20 21 Registration To register your product visit our website: fisherpaykel.
SAFETY AND WARNINGS ! WARNING! Electric Shock Hazard Failure to follow this advice may result in electric shock or death. • If the product is damaged, switch the appliance off and disconnect it from the power supply to avoid possible electric shock. ! WARNING! Cut Hazard Failure to use caution could result in injury. • Take care: some edges may be sharp. • Do not put fingers in the drawer when closing. ! WARNING! Hot Surface Hazard Failure to follow this advice could result in burns and scalds.
SAFETY AND WARNINGS ! WARNING! Fire Hazard Failure to follow this advice may result in overheating, burning, and injury. • Flammable materials should not be stored in the appliance or near its surface. WARNING! Tipping Hazard This product may tip. Keep children away and take care. Failure to follow this advice may result in injury. • The drawer must be secured in place by supplied screws. • Ensure there is a fixed shelf directly above the drawer if it is not installed under another product.
SAFETY AND WARNINGS READ AND SAVE THIS GUIDE WARNING! To reduce the risk of fire, electrical shock, injury to persons or damage when using the appliance, follow the important safety instructions listed below. Read all the instructions before using the appliance. Use the appliance only for its intended purpose as described in these instructions. General Use z z z z z z z This appliance has been designed for use in a normal domestic (residential) environment. Do not use the appliance outdoors.
SAFETY AND WARNINGS Safety z z z z z Do not touch hot surfaces. Use handles or knobs. Do not sit or lean on the appliance. Damage to the surface of the glass may cause it to shatter. Do not store hazardous objects that can explode like containers with gas or air chambers (e.g spray cans). Do not immerse cord, plug or other parts in water or other liquid to protect against electrical shock. Do not let the cord hang over the edge of table or counter, or in a heated oven.
BEFORE YOU BEGIN z z Ensure the installer has completed the final checklist in the installation instructions. Read this guide, taking special note of the Safety and warnings section.
BEFORE YOU BEGINPANTONE COOL GRAY 2 - THAT CAN BE BACKLIT WHITE Control panel 1 2 3 4 5 6 All layers printed and illuminated (locking layer) Control panel features 1 Power On/Off printed only 2 Temperature indicator 3 Temperature controls 4 Duration indicator 5 Duration controls 6 Heat modes GRAPHIC IS CORRECT IN SIZE AND SCALE WHEN LINE LENGTH IS CORRECT control panel 1. ALL ARTWORK MUST BE APPROVED PRIOR TO MANUFACTURE 2. ALL ARTWORK HIGHLIGHTED YELLOW REPRESENTS LEDS: 750329 WHITE QTBRIGHTEK 3.
USING YOUR WARMING DRAWER First time use If using the Warming Drawer for the first time, three LEDs in temperature controls are illuminated at start up. 1 For push-to-open models, touch the centre-front of the drawer to open. Do not force the drawer open. 2 Touch the 3 Select the desired heating function. If no function is selected, the drawer will start at default setting. button to switch the drawer ON. Press the centre of the door to close the drawer.
FUNCTIONS Your Warming Drawer is designed to utilise the heated glass base and rear fan in differing heat levels and durations to provide optimal performance. Each function has a default time and temperature setting that illuminates upon selection. These settings can be customised by manually adjusting the duration and temperature controls in place of a pre-set function. CUPS Heat circulates from the heated glass base z z z Heat is circulated for 30 minutes.
FUNCTIONS RAPID PROOF Gentle heat is generated from heated glass base z z Heat is produced for 30 minutes. Provides a warm and draft-free enviroment for proofing dough for bread making or pizza. DEHYDRATE Heat circulates from the heated glass base and rear fan z z z z z z Heat is circulated for four hours. Provides constant low heat for dehydrating and drying food eg meat, fruit, vegetables and herbs. Ideal for preserving food and creating healthy snacks, such as beef jerky, and fruit leather.
DELAYED START When using Delayed Start, the Warming Drawer will automatically switch on at a set time and turn off at the end of a cycle. 1 For push-to-open models, press the centrefront of the drawer to open. Do not force the drawer open. 2 Touch the function. 3 Touch and hold the button for five seconds to activate DELAYED START. 4 button and select the desired Use and to increase or decrease the desired DELAYED START time.
SABBATH MODE This setting is designed for religious faiths that observe a ‘no work’ requirement on the Sabbath. While your drawer is in SABBATH MODE, operation of up to 72 hours can be set and the safety shut-off and illumination features are deactivated. Activating SABBATH MODE: 1 Touch the button for 10 seconds to activate SABBATH MODE. 2 The temperature and duration indicators will illuminate briefly three times to indicate SABBATH MODE has been enabled.
LOADING YOUR APPLIANCE For WB24S models 20 Cappuccino cups 42 Espresso cups Diameter guide Diameter guide 20x Ø3 5/8” (92 mm) 48x Ø2 1/4” (58mm) Plate settings Mixed load Diameter guide 6x Ø9 13/16” (250mm) Dinner 6x Ø9 1/16” (230mm) Soup bowl 6x Ø7 1/16” (180mm) Bread & Butter 6x Ø6 1/2” (165mm) Saucer 15
LOADING YOUR APPLIANCE For WB30S models 24 Cappuccino cups 54 Espresso cups Diameter guide Diameter guide 20x Ø3 5/8” (92 mm) 48x Ø2 1/4” (58mm) Plate settings Mixed load Diameter guide 16x Ø9 13/16” (250mm) Dinner 16x Ø9 1/16” (230mm) Soup 16x Ø7 1/16” (180mm) Bread & Butter 16x Ø6 1/2” (165mm) Saucer Maximum load Do not load more than 55lbs (25kg) to prevent damage to the appliance.
USING THE WIRE SHELF The wire shelf is available for all WB30 models to increase the loading surface. wire shelf Insert the wire shelf in the left or right hand side of the Warming Drawer.
COOKING CHARTS The information in these charts is for guidance only. Refer to your recipe or the packaging and be prepared to adjust the cooking times and settings accordingly.
COOKING CHARTS FOOD TYPE FUNCTION TIME Dehydrate 4-8 hrs Ginger Dehydrate 4-6 hrs Carrots, Peas, Beans, Mushrooms, Tomatoes Dehydrate 4-6 hrs Dehydrate 2-4 hrs BREAD DOUGH Rapid Proof 30 mins PIZZA DOUGH Rapid Proof 30 mins FRUIT Apple, Pear, Banana, Peach, Pineapple, Apricots VEGETABLES HERBS Rosemary, Dill, Thyme, Bay leaves, Oregano FUNCTION TEMPERATURE SETTING DURATION RECOMMENDED COOKWARE TIPS YOGHURT Rapid Proof Low (1) 5-8 hrs Glass Jars/Ramekins Covered MELTING CHOCOL
CARE AND TROUBLESHOOTING Cleaning the drawer exterior and interior Ensure that the appliance is turned off or set in STANDBY MODE before cleaning. Do not use high pressure or steam cleaners. Remove any soiling or excess cleaning solution immediately. Clean the surfaces with a soft cloth dampened with water and detergent. Rub in the direction of the polish lines and dry immediately with a soft cloth.
SERVICE AND WARRANTY Before you call for service or assistance Refer to the installation guide and your user guide to: z z z z Ensure your product is correctly installed. Ensure you are familiar with its normal operation. Check the model and serial numbers. Check the date of installation. If after checking these points you still need assistance or parts, please refer to the Service & Warranty book for warranty details and your nearest Service Centre, Customer Care, or contact us through our website www.
FISHERPAYKEL.COM © Fisher & Paykel Appliances 2021. All rights reserved. The models shown in this guide may not be available in all markets and are subject to change at any time. The product specifications in this guide apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time.