User Manual

13
BEFORE YOUR FIRST WASH
Before you start, mark (

) accordingly if you have gone through the
checklist below:

1
Have the packaging and transit bolts been removed?
2
Is the drain hose threaded through the hose guide ‘Ubend’ (with no more
than 20mm extended) and hooked into your standpipe or tub, or attached
toa spigot?
3
Is the hot water hose connected to the hot valve (colour-coded orange)?
4
Is the cold water hose connected to the cold valve (colour-coded grey)?
5
Have the taps been turnedon?
6
Is the machine correctly levelled, feet are locked and cabinet corners clear
ofthe floor and walls?
5
Has the power cord been connected to an appropriate power supply
andthepower turned on?
6
Have you performed the installation test cycle?
7
We recommend that you complete your first cycle of use without a load
and only a half-dose amount of detergent in order to remove any residues
remaining in the machine from the manufacturing process.
IMPORTANT!
You must ensure all 4transit bolts have been removed from your washer before
youstart using it. If the transit bolts are not removed, they will damage your washer
and YOUR MANUFACTURER’S WARRANTY WILL BE COMPROMISED.