Installation Guide
9
COMPLETE INSTALLATION
z
Turn on the water and check all hose connections for leaks. Make sure there are no kinks in
the hose(s). Check the hose connections for leaks again after 24hours.
z
Uncoil power cord, remove and discard the plastic pin cover, and plug into wall socket.
z
Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
Test cycle
Your washer must be correctly installed before use. To check the installation and operation of
the washer follow the steps below:
1
Press POWER to activate your washer.
2
Select a QUICK cycle. Ensure the drum is
empty and the door closed.
3
Press to start.
If there are any problems, you must address these before proceeding with normal use. The
washer will automatically turn off at the end of the cycle if there are no problems.
A test cycle must be carried out anytime the washer is moved or tipped, this will ensure
the washer has been correctly re-installed.
4
Wait until you see water in the bottom of
the drum.
Press
to stop the cycle, then press
POWER to turn the washer off.
Activate the washer again by pressing
POWER
, press ADJUST or to select SPIN cycle
and to confirm.
Press
to begin the spin.
Check the drain hose is firmly secured to the
standpipe or tub, or spigot.
Observe that the washer pumps out the
water, and spins.
The washer will beep to signal the end of
the cycle. Any faults will be displayed on the
screen, refer your user guide.
5
6
Spin
Utility
Spin
Utility
Spin
Utility
Spin
Utility
Spin
Utility
Spin
Utility