Installation Guide

34
WASH CYCLE OPTIONS
Options
Soak (WH2424F model only)
A soak option is available on selected wash cycles. When this option is chosen the
machine will add a one hour soak sequence, which combines periods of tumbling with
soaking to help lift stubborn stains.
If ‘Soak’ and ‘Time Saver’ are selected in the same cycle, the soak duration will be
reduced to 30 minutes.
‘Soak’ is not available on the ‘Wool’, ‘Drum Clean’, ‘Quick’, ‘Rinse’ or ‘Spin’ Cycles.
Wrinkle Free
We recommend you remove the clothes from the washer immediately after the
completion of the cycle to minimize wrinkling and creasing of items and to prevent
dyerun. However, if you will not be present at the end of the cycle you can select
‘Wrinkle Free’.
When ‘Wrinkle Free’ is selected, the washer will tumble the clothes once every
15minutes for up to 12 hours after the cycle has finished. The ‘Wrinkle Free’ light and
button will flash, and the washer will beep at regular intervals to remind you to
remove your load. To remove the load during this phase, simply press the button.
Eco
Use the ‘Eco’ option to save water and energy. Selecting ‘Eco’ will reduce the wash
temperature slightly and alter the wash and rinse programming.
Note: this option will not be available if ‘Rinse +’ has been selected.

If you wish to, you can select both the ‘Pre Wash’ and ‘Rinse+’ ‘Wash Boost’ options
to perform on the same cycle. Likewise, you can select ‘Eco’ and ‘Wrinkle Free’ to
perform on the same cycle. Touch the appropriate button until both options are
selected. Repeat to deselect an option.

For clothes care and performance reasons not all options may be available on some
cycles.
Add a Garment
The ‘Add a Garment’ option enables you to add or remove items during the wash stage
of the cycle, under certain conditions. Once the ‘Add a Garment’ button is touched,
the button and time to go will flash. Wait until you hear the door unlock. Open the
door and add or remove items. Close the door and touch to restart the cycle. The
‘Add a Garment’ button will only operate during the wash part of the cycle and when
the temperature selected is lower than ‘Hot’ temperature. ‘Add a Garment’ can be used
when the total wash volume has been reached, as your washer will drain the water to a
lower level if necessary, so the door can be opened.