User Manual
8
Location
This machine must not be installed and operated on a plinth.
Levelling the machine
It is IMPORTANT to level the machine to ensure good spin performance, and to minimise
noise, vibrations and wear and tear on the washer.
1 Before positioning the machine in its final position, check that the machine is level,
front to back and side to side.
2 Manoeuvre the product into its final position (we suggest a
minimum clearance of 20mm each side).
3 Use a spirit level to check that the machine is correctly
level. If needed, pull the machine out. Loosen the lock nut
using the spanner provided and wind the feet up or down
to correctly level the machine.
4 Using the spanner provided, tighten the lock nuts against
the base of the machine to lock the feet in position.
Connecting to the water supply
Inlet hose(s)
1 Connect the straight end(s) of the inlet hose(s) to the
tap(s) and the elbow end(s) to the corresponding machine
inlet valve(s). If present, the hot valve is colour coded
orange. Tighten the inlet hose end(s) by hand until the
hose seal just makes contact with the tap sealing face
and then tighten a further half-turn. Make sure there
are no kinks in the hose(s).
2 Turn the tap(s) on and check for leaks. Check for leaks
again after 24hours.
Locking the feet
Inlet hose ends
Elbow
(machine)
end
Straight
(tap) end
INSTALLATION INSTRUCTIONS