User Manual
9
If you have an uncontrolled water heating source (eg a wet back or solar heating system)
please contact a qualified plumber to have a Hot āNā Safe Valve fitted . This will ensure the
hot water temperature remains within safe limits.
Water supply requirements:
z
Inlet water pressure: Maximum 1MPa (150psi), Minimum 30kPa (4.5psi)
z
Inlet water flow rate: Minimum 6īlitres/minute
Cold supply only:
If you only have a cold water supply, the inlet valve cap (blanking cap) which came with
your washer must be connected to the hot inlet valve (with the exception of WH9060J,
WH8560J, WH8060J and WH7560J models). The cap prevents water leaking out of the hot
valve. This appliance incorporates backflow protection complying with AS3500.1. No further
backflow protection is required for connection to the water supply.
Your washer has an internal heater to heat water. If your model of washer has cold water
connection only (WH9060J, WH8560J, WH8060J and WH7560J models), or if you do
not connect a hot water inlet hose, your washer will automatically recognise there is no
hot water supply and its internal heater will heat the cold water to the selected cycle
temperature.
INSTALLATION INSTRUCTIONS