User Manual
11
Electrical connection
1 This appliance must be connected to a 220V – 240V, 50Hz, sinusoidal, minimum 10A
electricalsupply.
2 Uncoil the power cord, remove and discard the plastic pin cover and plug
into a wallsocket.
3 Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
z
Check the power cord for damage and make sure it is not squashed or twisted when
installing the washer.
z
Always remove the power cord from a socket by the plug, not by the cord.
SPARE PARTS* PART NO.
Hose inlet long (2m) 422680P
Hose inlet large bore 426123P
Drain hose extension (not suitable for attaching to a spigot) 425627P
*Available from your Fisher & Paykel dealer or a Fisher & Paykel trained and supported service technician.
Completing the installation
Installation test cycle
Do this before you wash any items in your washer. This is to check that your washer is
installed correctly and that it is functioning correctly prior to use.
1 Turn your washer on by pressing ‘Power’.
2 Select the ‘Quick’ or ‘Super Quick’ cycle. Ensure the drum is empty and the door closed.
3 Touch the
button. The machine will start to fill.
z
Observe the machine for any problems (eg leaking from the hose(s), excess noise
orvibrations).
z
The washer will beep and display any faults on the screen if there are any problems.
Refer to ‘Before you call for service’ at the back of this book.
4 Wait until you see water in the bottom of the drum.
5 Touch
to stop the cycle, then press ‘Power’ to turn the machine off.
6 Press ‘Power’ again, select the ‘Spin’ cycle and touch
.
z
Check the drain hose is firmly secured to the standpipe or tub, or spigot.
z
Observe that the machine pumps out the water, and spins.
If there are any problems, you must address these before proceeding with normal use.
The washer will automatically turn off at the end of the cycle if there are no problems.
INSTALLATION INSTRUCTIONS