User Manual
29
WASH CYCLE OPTIONS
Options
Soak (WH8560F and WH8060F models only)
A soak option is available on selected wash cycles. When this option is chosen the machine
will add a one hour soak sequence, which combines periods of tumbling with soaking to
help lift stubborn stains.
If ‘Soak’ and ‘Time Saver’ are selected in the same cycle, the soak duration will be reduced
to 30 minutes.
‘Soak’ is not available on ‘Wool’, ‘Drum Clean’, or ‘Super Quick’ cycles.
Wrinkle Free
(WH8560F, WH8060F, WH8560P WH8060P and WH7560P models only)
We recommend you remove the clothes from the washer immediately after the completion
of the cycle to minimise wrinkling and creasing of items and to prevent dye run. However, if
you will not be present at the end of the wash you can select ‘Wrinkle Free’.
When ‘Wrinkle Free’ is selected, the washer will tumble the clothes once every 15minutes
for up to 12 hours after the cycle has finished. The ‘Wrinkle Free’ light and
button will
flash, and the washer will beep at regular intervals to remind you to remove your load. To
remove the load during this phase, simply press the button.
Eco/Eco Rinse
Use the ‘Eco’/’Eco Rinse’ option to save water and energy. Selecting ‘Eco’/’Eco Rinse’ will
reduce the wash temperature slightly and alter the wash and rinse programming.
This option will not be available if ‘Pre Wash’ has been selected.
z
If you wish to, you can select both the ‘Pre Wash’ and ‘Rinse+’ ‘Wash Boost’ options
to perform on the same cycle. Likewise, you can select ‘Eco’/’Eco Rinse’ and ‘Wrinkle
Free’ to perform on the same cycle. Touch the appropriate button until both options are
selected. Repeat to deselect an option.
z
For clothes care and performance reasons not all options may be available
on some cycles.
Add a Garment
(WH8560F, WH8060F, WH8560P, WH8060P and WH7560P models only)
The ‘Add a Garment’ option enables you to add or remove items during the wash stage of
the cycle, under certain conditions. Once the ‘Add a Garment’ button is touched, the
button and time to go will flash. Wait until you hear the door unlock. Open the door and
add or remove items. Close the door and touch to restart the cycle.
The ‘Add a Garment’ button will only operate during the wash part of the cycle and when
the temperature selected is lower than 60°C. ‘Add a Garment’ can be used when the total
wash volume has been reached, as your washer will drain the water to a lower level if
necessary, so the door can be opened.