User Manual

36
BEFORE YOU CALL SERVICE
PROBLEM DISPLAYED AS WHAT TO DO
Wash load
is out of
balance
Touch to try the spin again.
If the out of balance persists, pause the cycle,
manually redistribute the load and touch
to
spin again. If necessary, stop the cycle, select ‘Spin’
and touch .
If the problem persists, check the machine is
correctly levelled.
Too many
suds
Machine will stop and flash for
10minutes while waiting for suds to dissipate. The
machine will not beep during this time. After 10
minutes the machine will automatically restart. At
any point during that 10 minutes you can touch
to restart the machine, but it is recommended that
the machine be left to restart automatically.
Check you are using a suitable detergent.
Check you are not overdosing the detergent.
Check the standpipe height for the drain does not
exceed 1200mm.
Door is
locked
The temperature in the drum is over 60°C
therefore it is not safe to open the door. Wait until
the temperature drops below 60°C.
Check the water level in the drum. If the level
is above the bottom of the door seal, the door
cannot be opened. Use the ‘Add a Garment’ button
if you wish to add or remove items (WH8560F,
WH8060F WH8560P, WH8060P and WH7560P
models only).
If the drum is still moving, wait for it to stop before
attempting to open the door.
Door is open
Close the door fully and touch .
Try opening and closing the door again.
Reposition the load, make sure the load is correctly
in the drum and that protruding items are not
stopping the door from closing.