User's Manual
Table Of Contents
- Contents
- Safety and warnings
- Installation guide
- Before your first wash
- Safety features
- Control panel
- Wash cycles
- Detergent and softener
- Where to put the detergent
- Wash preparation
- Getting started quickly
- Wash cycle options
- Customising a wash cycle
- Changing pre-set options
- Caring for your washer
- Before you call for service
- Fault codes
- Troubleshooting
- Manufacturer’s warranty
- Customer care
INSTALLATION GUIDE
13
Complete your installation
z
Turn on the water and check all hose connections for leaks. Make sure there are
no kinks in the hose(s). Check the hose connections for leaks again after 24hours.
z
Uncoil power cord, remove and discard the plastic pin cover, and plug into
the wall socket.
z
Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
Test cycle
Your washer must be correctly installed before use. To check the installation and operation
of the washer follow the steps below:
1
Press to activate your washer.
2
Select a QUICK cycle. Ensure the drum is
empty and the door closed.
SPARE PART* PART NO.
Hose inlet long (2m) 422680P
Hose inlet large bore 426123P
* Available from your Fisher&Paykel dealer or a Fisher&Paykel trained and supported service technician
Electrical connection
z
This appliance must be connected to a 220V – 240V, 50Hz, sinusoidal, minimum 10A
electricalsupply.
z
Check the power cord for damage and make sure it is not squashed or twisted when
installing the washer.
z
Always remove the power cord from a socket by the plug, not by the cord.
Spare Parts