User's Manual
Table Of Contents
- Contents
- Safety and warnings
- Installation guide
- Before your first wash
- Safety features
- Control panel
- Wash cycles
- Detergent and softener
- Where to put the detergent
- Wash preparation
- Getting started quickly
- Wash cycle options
- Customising a wash cycle
- Changing pre-set options
- Caring for your washer
- Before you call for service
- Fault codes
- Troubleshooting
- Manufacturer’s warranty
- Customer care
15
BEFORE YOUR FIRST WASH
Check you have done everything you need to before you start your first wash:
Have the packaging and transit bolts been removed?
Is the washer correctly levelled, feet are extended and cabinet corners are clear of
the floor?
Is the drain hose threaded through the hose guide ‘U bend’ (with no more than
20mm extended) and hooked into your standpipe or tub, or attached to a spigot?
Have the taps been turned on?
Is the hot hose connected to the hot valve marked ‘H’?
Is the cold hose connected to the cold valve marked ‘C’?
Have you performed the test cycle? Refer to ‘Installation guide’.
Has the power cord been connected to an appropriate power supply and the power
turned on?
Complete a Drum Clean cycle with half-load amount of detergent and without a load
in order to remove any residues remaining in the machine from the manufacturing
process.