User's Manual
Table Of Contents
- Contents
- Safety and warnings
- Installation guide
- Before your first wash
- Safety features
- Control panel
- Wash cycles
- Detergent and softener
- Where to put the detergent
- Wash preparation
- Getting started quickly
- Wash cycle options
- Customising a wash cycle
- Changing pre-set options
- Caring for your washer
- Before you call for service
- Fault codes
- Troubleshooting
- Manufacturer’s warranty
- Customer care
17
When power is restored, your washer will resume the interrupted wash cycle. If the cycle
doesn’t resume automatically, simply press to restart your washer.
SAFETY FEATURES
Opening the door during a power failure
If there is a power failure during a wash cycle your washer will stop and the door will
remain locked.
Locate thepump filter cover at the bottom
right of your washer.
Place a coin or key in the slot and tilt it
upwards to lever the cover open.
1
2
Pull the door release tab down from the ring.
Use a screwdriver tip, pen or key to get a
good grip.
3
Do not attempt to do this if the water level inthewasher is above the bottom of thedoor.