User Guide

INSTALLATION INSTRUCTIONS
10
Pull hose
through
guide
Flex hose
guide apart
Standpipe 850 – 1200 mm
(20 mm)
maximum
Fitting the drain hose guide
SPARE PARTS* PART NO.
Hose inlet long (2m) 422680P
Hose inlet large bore 426123P
Drain hose extension (not suitable for attaching to a spigot) 425627P
*Available from your Fisher&Paykel dealer or a Fisher&Paykel trained and supported
service technician.
Draining
To prevent siphoning the drain hose should not extend more than 20mm from the end of
the guide. The height of the standpipe or tub should be between 850 – 1200mm. The drain
hose can be trimmed to length.
z
Regularly check that your standpipe or tub is free from lint or other obstructions, which
may affect how your washer works or may cause flooding.
z
In multi-storey apartments or any upper floor, the washer should be installed on a floor
equipped with a drain.
z
Draining must comply with local by-laws.
z
We recommend replacing the inlet hoses every 5 years. Hoses should be checked from
time to time and replaced if any wear, cuts, bulges, kinks or leaks are found.
Electrical connection
z
This appliance must be supplied with a 220 – 240V, 50Hz, sinusoidal,
10Aelectrical supply.
Placing the drain hose in a standpipe or tub:
1 Carefully pull the drain hose out from the
back of the washer by pulling the exposed
part of the hose downward and outward.
2 To guide the drain hose over the tub or
standpipe the hose guide MUST be fitted to
the drain hose.
3 Place the drain hose in the tub or standpipe.
Do not fit the hose to a drain spigot. Drainage
must not be airtight in order to prevent
siphoning.