User Guide
Table Of Contents
- User Guide
- Contents
- Safety and warnings
- Safety features
- Control panel
- Wash cycles
- Detergent and softener
- Wash preparation
- Getting started quickly
- Customising a wash cycle
- Changing pre-set options
- Factory reset
- Caring for your washer
- Before you call for service
- Fault codes
- Troubleshooting
- Energy consumption and cycle times
- Manufacturer’s warranty
- Customer care
- European Directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE)
31
Cleaning the pump filter
The pump filter must be checked and cleaned at least every 6 months.
CARING FOR YOUR WASHER
Unhook the pump outlet hose and pull it out
(approximately 150mm). Remove the plug
and allow any water (approximately 250ml)
to drain into a shallow dish.
After the draining process is complete,
replace the plug intothe hose and refit the
hose back into the housing.
Turn the power off and unplug the washer.
Use a coin to open the filter cover, place the
edge of the coin into the slot and tilt upwards
whilst levering the cover open.
2
1
Replace the filter by turning clockwise until
the turning handle stops in the vertical
position, and cannot be turned further.
Remove the filter by turning anti-clockwise.
Clean and rinseunder a tap. Check the pump
filter cavity for any further obstruction. Check
that the impellor located at the back of the
cavity moves freely.
3
4