CMR41 Side-to-side Lado a lado Head-to-toe Adelante hacia atrás IMPORTANT! Keep these instructions for future reference. Please read these instructions before assembly and use of this product. Product features and decorations may vary from photographs and diagrams. ¡IMPORTANTE! Guardar estas instrucciones para futura referencia. Leer estas instrucciones antes de ensamblar y usar este producto. Las características y decoración del producto pueden variar de las mostradas. fisher-price.
Consumer Information Información para el consumidor WARNING Prevent death: Keep seat fully reclined until child is at least 4 months old AND can hold head up without help. Young infants have limited head and neck control. If seat is too upright, infant’s head can drop forward and compress the airway, resulting in DEATH. Prevent serious injury or death from falls or strangling in the restraint system: • Never leave child unattended.
Consumer Information Información para el consumidor • Adult assembly is required. Tools needed for assembly: Allen wrench (included) and Phillips screwdriver (not included). • Requires two C (LR14) alkaline batteries (not included) for seat vibration. • Requires AC adapter (included) (input 100 - 240 VAC, 50 - 60Hz, with an output of 6 VDC) for swing operation. • Always use the swing where there is adequate ventilation.
Parts Piezas Link Toy Juguete que se conecta Mobile M bil Móvil Seat with Soother (We recommend installing batteries into the soother before beginning assembly. See Soother Battery Installation on page 13). Asiento con unidad de vibraciones (Instalar las pilas en la unidad de vibraciones antes de empezar el montaje. Ver la sección de colocación de las pilas de la unidad de vibraciones en la página 13).
Parts Piezas M5 x 45 mm Screw – 1 (This screw is located in the upper seat tube retainer. You will need to remove it to assemble the upper seat tube to the seat tube.) Tornillo M5 x 45 mm – 1 (Este tornillo se encuentra en el retenedor del tubo de asiento superior. Será necesario quitarlo para ensamblar el tubo de asiento superior en el tubo de asiento.) M4,5 x 19 mm Screw – 4 Tornillo M4,5 x 19 mm – 4 M3 x 31 mm Screw - 1 Tornillo M3 x 31 mm – 1 All fasteners shown actual size.
Assembly Montaje IMPORTANT! Before each use or assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. Do not use the product if any parts are missing, damaged or broken. Do not use accessories or replacement parts other than those approved by the manufacturer. ¡IMPORTANTE! Antes del montaje y de cada uso, revisar que el producto no tenga piezas dañadas, conexiones sueltas, piezas faltantes o bordes filosos. NO usar el producto si falta o está rota alguna pieza.
Assembly 2 Montaje BACK VIEW VISTA DE ATRÁS • Plug the power cord from the upper frame tube into the power cord in the lower frame tube. • Enchufar el cable eléctrico del tubo del armazón superior en el cable eléctrico del tubo del armazón inferior. Seat Arm Brazo de la silla Seat Arm Brazo de la silla 3 Seat Asiento Install batteries into the soother Instalar las pilas en la unidad de vibraciones x4 Note: Before completing this assembly step, we recommend installing batteries into the soother.
Assembly Montaje Remove this screw Quitar este tornillo 4 FRONT VIEW VISTA DEL FRENTE IMPORTANT! The screw used to assemble the seat tube to the upper seat tube is located in the upper seat tube retainer. Loosen the M5 x 45 mm screw in the upper seat tube retainer with the Allen wrench and remove it. This screw will be used in assembly step 6. ¡IMPORTANTE! El tornillo para ensamblar el tubo del asiento al tubo de asiento superior se encuentra en el retenedor del tubo del asiento superior.
Assembly Montaje 6 x1 • Insert the M5 x 45 mm screw into the upper seat tube retainer and tighten with the Allen wrench. Make sure the screw is fully tightened. • Insertar el tornillo M5 x 45 mm en el retenedor del tubo del asiento superior y apretarlo con la llave hexagonal. Asegurarse de que el tornillo esté bien apretado. Pad Almohadilla 7 Soother Unidad de vibraciones • Fit the large opening in the pad around the soother.
Assembly Montaje Lowest Slots Ranuras inferiores 8 • Insert the waist belts through the lowest slots in the pad. Make sure the waist belts are not twisted. • Insertar los cinturones de la cintura en las ranuras inferiores de la almohadilla. Asegurarse de que los cinturones no estén torcidos. Lower Slots Ranuras inferiores 9 Smaller Baby • Insert the ends of the shoulder belts through the lower slots in the pad.
Assembly Montaje Upper Slots Ranuras superiores 10 Larger Baby • This product is shipped with the shoulder belts installed in the lower slots in the seat. For a larger baby, you will need to push the ends of the shoulder belts back through back side lower slots in the seat. Then, fit the shoulder belt ends through the front side upper slots in the seat. Pull on the shoulder belts to be sure they are secure in the seat. • Insert the shoulder belts through the upper slots in the pad.
Assembly 12 Montaje Body Support Soporte corporal • Insert the restraint pad through the large slot, the waist belts through the lower slots and the shoulder belts through the upper slots in the body support. • Clip the link on the toy to the restraint pad. • Insertar la almohadilla de sujeción en la ranura grande, los cinturones de la cintura en las ranuras inferiores, y los cinturones de hombro en las ranuras superiores del soporte corporal. • Conectar el aro del juguete en la almohadilla de sujeción.
Soother Battery Installation Colocación de las pilas de la unidad de vibraciones 1,5V x 2 C (LR14) For longer life, use alkaline batteries. Para una mayor duración, usar solo pilas alcalinas. BOTTOM VIEW VISTA DE ABAJO • Locate the soother battery compartment underneath the seat. • Loosen the screw in the battery compartment door with a Phillips screwdriver and remove the door. • Insert two, C (LR14) alkaline batteries into the battery compartment.
Setup and Use Preparación y uso WARNING Prevent death: Keep seat fully reclined until child is at least 4 months old AND can hold head up without help. Young infants have limited head and neck control. If seat is too upright, infant’s head can drop forward and compress the airway, resulting in DEATH. Prevent serious injury or death from falls or strangling in the restraint system: • Never leave child unattended. • This product is not intended to replace a crib or bassinet for prolonged periods of sleep.
Restraint System Sistema de sujeción Shoulder Belt Cinturón de hombro Shoulder Belt Cinturón de hombro Waist Belt Cinturón de la cintura Waist Belt Cinturón de la cintura 1 Restraint Pad Almohadilla de sujeción • Place your child in the seat. Position the restraint pad between your child's legs. • Fit the end of each waist belt through the end of each shoulder belt. • Fasten the waist/shoulder belts to the restraint pad. Make sure you hear a "click" on both sides.
Restraint System 3 TIGHTEN APRETAR Sistema de sujeción LOOSEN AFLOJAR • To tighten the waist belts: Feed the anchored end of the belt up through the buckle to form a loop A . Pull the free end of the belt B . Repeat this procedure to tighten the other belt. • To loosen the waist belts: Feed the free end of the belt up through the buckle to form a loop A . Enlarge the loop by pulling on the end of the loop toward the buckle. Pull the anchored end of the belt to shorten the free end of the belt B .
Adjust Seat Motion Ajustar el movimiento de la silla Side-to-side Lado a lado Head-to-toe Adelante hacia atrás • While holding the sides of the swing seat, turn the seat to adjust the motion direction to side-to-side or head-to-toe. • Mientras sujeta los lados de la silla del columpio, voltear la silla para ajustar la dirección del movimiento de lado a lado o adelante hacia atrás.
Swing AC Power Uso del columpio con corriente alterna • Place the swing near a standard wall outlet. • Insert the AC adapter pin into the socket in the swing base. • Plug the AC adapter into the wall outlet. • Use the AC adapter only in a wall outlet. Do not plug the AC adapter into a ceiling outlet. IMPORTANT! AC power does not power seat calming vibrations. The seat soother is powered separately with two, C (LR14) alkaline batteries installed in the underside of the seat.
Swing Power, Music, Sounds and Light Settings Opciones de luz, música y sonidos y encendido del columpio Press the power button to turn swing power ON. Presionar el botón de encendido para ENCENDER el columpio. LED Display Luces LED Press the swing speed buttons to adjust the swing speed. LED display lights up to indicate the speed setting. Presionar los botones del volumen para ajustar el volumen. Las luces LED se iluminan para indicar el nivel del volumen.
Calming Vibrations Vibraciones relajantes Power Button Botón de encendido • Press the power button on the soother to turn calming vibrations ON or OFF. Hint: Vibrations will time out after approximately 30 minutes. Press the power button again to restart. • Presionar el botón de encendido de la unidad de vibraciones para PRENDER o APAGAR las vibraciones relajantes. Atención: después de aproximadamente 30 minutos, las vibraciones se apagarán. Volver a presionar el botón para reiniciarlas.
Battery Safety Information Información de seguridad acerca de las pilas In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage: • Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium). • Insert batteries as indicated inside the battery compartment. • Remove batteries during long periods of non-use.
Adults Note: Periodically examine the AC adaptor for damage to the cord, housing or other parts that may result in the risk of fire, electric shock or injury. If the AC adaptor is damaged, do not use the product. Atención padres: revisar periódicamente que el adaptador de corriente alterna no tenga daños en el cable, compartimento u otras piezas que pueden resultar en incendio, descarga eléctrica o lesiones. Si el adaptador de corriente alterna está dañado, no usar el producto.
Consumer Information Información para el consumidor FCC STATEMENT (UNITED STATES ONLY) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
CO SU CONSUMER ASSISTANCE SS S ATENCIÓN AL CLIENTE 1-800-432-5437 (US) Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052. Hearing-impaired consumers/Clientes con problemas auditivos 1-800-382-7470. Centro de Servicio en México: 59-05-51-00 Ext. 5206 ó 01-800-463-59-89 MÉXICO Importado y distribuido por Mattel de México, S.A. de C.V., Miguel de Cervantes Saavedra No. 193, Pisos 10 y 11, Col. Granada, Delegación Miguel Hidalgo, C.P. 11520, México, D.F. R.F.C. MME-920701-NB3.
