Deluxe Take-Along™ Swing Model Number: 79618 Please keep this instruction sheet, as it contains important information. Adult assembly is required. Tool needed for battery installation: Phillips Screwdriver. Requires four “C” (LR14) alkaline batteries for operation (not included). Weight Limit: 17 lbs (7.7 kg). IMPORTANT! The maximum weight limit for this product is 17 lbs. If your child weighs less than 17 lbs.
Warnings WARNING • To prevent falls: - Never use with an active child who may be able to climb out. - Never use on any elevated surface. • To prevent injury or death from falls or sliding out, always use restraint system. • Never leave child unattended. Consumer Information Occasionally a consumer may experience a problem with one of our products. If this should happen, please call us toll-free, rather than return this product to the store.
Parts Frame with Liner Pad with Restraint Front Tube 2 Frame Tubes 3
Assembly IMPORTANT! Before assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Fisher-Price® for replacement parts and instructions if needed. Never substitute parts. 1 Upper Frame Tube • Rotate the upper frame tube until it "snaps" into an upright position, as shown.
Assembly Lower Frame Tubes 3 Pull Front Tube • Pull the front tube to be sure it is secure to each lower frame tube. Frame with Liner Press Button on Upper Frame Tube Seat 4 Front Tube • Position the frame with liner so that the seat is over the front tube. • While pressing the buttons on the upper frame tubes, insert them into the holes in the underside of the frame with liner. • Continue to insert the upper frame tubes into the frame with liner until you hear a "click" on both sides.
Assembly Frame with Liner Upper Frame Tube Upper Frame Tube 5 • Check to be sure the upper frame tubes are secure in the frame with liner. If you can remove the upper frame tubes from the frame with liner, you have not properly inserted the tubes into the frame. Remove the upper frame tubes from the frame with liner and repeat Assembly step 4. IMPORTANT! Attach the provided pad (with restraint system) to this product. Never use this product without the provided pad.
Assembly Waist Belts Pad Slot 7 Slot • Pull the edges of the pad up slightly and insert the waist belts on the liner through the slots in the pad. Assembly is now complete.
Battery Installation Battery Compartment Door Battery Holder • Locate the battery compartment door on the frame. • Loosen the screw in the battery compartment door with a Phillips screwdriver. • Remove the battery compartment door and the battery holder from the battery compartment. Battery Holder • Open the battery holder. • Insert four "C" (LR14) alkaline batteries as indicated inside the battery holder. Hint: We recommend using alkaline batteries for longer battery life. • Close the battery holder.
Battery Installation Battery Holder Battery Compartment Door • Align the ridge on the battery holder with the groove in the battery compartment. • Slide the battery holder back into the battery compartment. • Replace the battery compartment door and tighten the screw with a Phillips screwdriver. Do not over-tighten.
Battery Tips 1.5V x 4 "C" (LR14) SHOWN ACTUAL SIZE • Do not mix old and new batteries. • Do not mix different types of batteries: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium). • Remove the batteries during long periods of non-use. Always remove exhausted batteries from the toy. Battery leakage and corrosion can damage this toy. Dispose of batteries safely. • Do not dispose of batteries in a fire. The batteries may explode or leak. • Never short circuit the battery terminals.
Securing Your Child WARNING • To prevent falls: - Never use with an active child who may be able to climb out. - Never use on any elevated surface. • To prevent injury or death from falls or sliding out, always use restraint system. • Never leave child unattended. Restraint Waist Belt Waist Belt 1 • Place your child in the seat. Position the restraint between your child’s legs. • Fasten both waist belts to each side of the restraint. Make sure you hear a "click" on each side.
Securing Your Child Free End Free End Anchored End B B Anchored End 2 Loosen Tighten To tighten the restraint: • Feed the anchored end of the restraint belt up through the buckle to form a loop . • Pull the free end of the restraint belt B . • Repeat this procedure to tighten the other restraint belt. To loosen the restraint: • Feed the free end of the restraint strap up through the buckle to form a loop . • Enlarge the loop by pulling on the end of the loop toward the buckle.
Starting the Swing IMPORTANT! Before each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Fisher-Price® for replacement parts and instructions if needed. Never substitute parts. Power Dial Power Dial • Turn the power dial to any of eight settings. • Give the seat a light push to start the swinging motion. Adjust the swing power dial to the desired swing motion setting.
Lights and Music! Hint: Your baby can enjoy lights and music with or without swinging. Baby Activated Lights and Music Switch Parent Activated Volume Dial Lights and Music Switch • Slide the lights and music switch to: baby activated lights and one song ; sound and lights off ; or parent activated lights and music . When baby pulls either toy on the arch, one tune plays along with twinkling lights. On this setting, six tunes (approximately 10 minutes) play along with dancing lights.
Room-to-Room Portability WARNING • To prevent falls: Never use on any elevated surface. • To prevent injury or death from falls or sliding out, always use restraint system. • Make sure your child is properly secured in the swing seat. • With baby facing forward and outward, lift the swing using the handle. • Carefully carry the swing to another room. Be sure to set the swing down on a non-elevated, flat surface.
Take-Along Seat Bottom Lift Seat Back Lift Seat Bottom 1 • Lift the seat back and seat bottom together. Straps Seat Back 2 • • • • Press Tab Press Tab Tip the swing backwards the seat back down. Unfasten the straps on the seat bottom. Pull the straps from the loops on the seat bottom. Press both tabs on the frame at the same time to release the frame base.
Take-Along Lower Frame Tube 3 • Rotate the lower frame tube around to the top of frame, as shown. Upper Frame Tube Strap 4 Lower Frame Tube • Fit the straps on the seat bottom between the upper and lower frame tubes, as shown. • Wrap the straps around the lower frame tubes and fasten the straps. To set the swing back up for use: • Unfasten the straps around the upper and lower frame tubes. • Replace the straps through the loops on the seat bottom and fasten.
Care • The pad is machine washable. Wash the pad separately in cold water on the gentle cycle. Do not use bleach. Tumble dry separately on low heat and remove promptly. The frame, liner and toys may be wiped clean using a mild cleaning solution and a damp cloth. Do not immerse the frame. • This product has no consumer serviceable parts. Do not take this product apart. IMPORTANT! Never use this product without the provided pad. Be sure to re-attach the provided pad (with restraint system) to this product.
One (1) Year Limited Warranty Fisher-Price, Inc., 636 Girard Avenue, East Aurora, New York 14052 warrants that the Deluxe Take-Along Swing is free from all defects in material and workmanship when used under normal conditions for a period of one (1) year from the date of purchase. Should the product fail to perform properly, we will repair or replace it at our option, free of charge.
FCC Statement (United States Only) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.