User Manual

ManualsBrandsFisher-Price Manualshigh chairsSpaceSaver High Chair

fisher-price.com

CLR36, CLR37, CLR38,

CLR39, CLR40, CLR41

Newborn

Recién nacido

Infant

Bebé

Toddler

Niño pequeño

• Please read these instructions before assembly and

use of this product.

• Keep this instruction sheet, as it contains

important information.

IMPORTANT! Before assembly and each use, inspect this

product for damaged hardware, loose joints, missing

parts or sharp edges. Do not use the product if any parts

are missing, damaged or broken. Do not use accessories

or replacement parts other than those approved by the

manufacturer. Never substitute parts.

• Adult assembly and setup is required. Tool required for

assembly: Phillips screwdriver (not included). Assembly

instructions on back side of this sheet.

• When attaching to an adult chair:

- Make sure the chair seat is level and larger than the

seat base.

- Check to be sure the floor surface beneath the chair

is level.

• Product features and decorations may vary from photos.

• Leer estas instrucciones antes del montaje y de usar

este producto.

• Guardar estas instrucciones para futura referencia,

ya que contienen información de importancia acerca de

este producto.

¡IMPORTANTE! Previo al montaje y al uso de la silla,

revisar que este producto no tenga piezas dañadas,

conexiones sueltas, piezas faltantes o bordes filosos.

NO usar el producto si falta o está rota alguna pieza. No

usar accesorios ni piezas de repuesto, salvo aquellos

aprobados por el fabricante. No usar piezas de terceros.

• Requiere montaje y configuración por un adulto.

Herramienta requerida para el montaje: desatornillador

de cruz (no incluido). Ver el dorso de esta hoja para

las instrucciones de montaje.

• Al ajustarla en una silla de adulto:

- Asegurarse que el asiento de la silla esté parejo y sea

más grande que la base de la silla.

- Asegurarse que el suelo abajo de la silla esté nivelado.

• Las características y decoración del producto pueden

variar de las mostradas.

Summary of content (12 pages)

PAGE 1
CLR36, CLR37, CLR38, CLR39, CLR40, CLR41 • Please read these instructions before assembly and use of this product. • Keep this instruction sheet, as it contains important information. IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. Do not use the product if any parts are missing, damaged or broken. Do not use accessories or replacement parts other than those approved by the manufacturer. Never substitute parts.
PAGE 2
Seat Care Mantenimiento de la silla • The seat, seat back and seat attachment straps may be wiped clean using a mild cleaning solution and damp cloth. Do not use bleach. Do not use harsh or abrasive cleansers. Rinse clean with water to remove residue. • Pasarles un paño humedecido en una solución limpiadora neutra a la silla, respaldo y cinturones. No usar blanqueador. No usar limpiadores fuertes o abrasivos. Enjuagar con agua para eliminar el residuo.
PAGE 3
WARNING: Prevent serious injury or death from sliding out, falls or tipping over. • Always secure child with the restraint system adjusted to fit child snugly. The tray is not designed to hold child in the product. Use the restraint system until child is able to get in and out of the product without help (about 2 ½ years old). • Never leave child unattended. • Never allow child to push away from a table while in this product. • Attach this product to an adult chair using bottom and back attachment straps.
PAGE 4
Adjusting Seat Height Ajustar la altura de la silla Adjusting Seat Recline Ajustar el respaldo de la silla B B A PULL JALAR A • While pulling the seat recline handle on the back of the seat, lift or lower the seat back to the desired position. • Release the seat recline handle. • Push on the seat back to be sure the seat is secure. Hint: You may not be able to fully recline this product when attached to some adult chairs.
PAGE 5
Attaching to a Chair Ajustar a una silla D D Bottom Straps Cinturones inferiores A Back Straps Cinturones traseros B C F E 1 2 • Place the seat on a chair. • Wrap the bottom straps around the bottom of the chair A . Buckle the straps B . Make sure you hear a "click". Pull the free end of the strap to tighten on the chair C . • Wrap the back straps around the back of the chair D . Buckle the straps E . Make sure you hear a "click". Pull the free end of the strap to tighten on the chair F .
PAGE 6
Secure Child Waist Belt Cinturón de seguridad Sistema de sujeción Waist Belt Cinturón de seguridad Adjuster Ajustador C C B B A A 2 TIGHTEN APRETAR • To tighten the waist belts: Feed the anchored end of the waist belt up through the buckle to form a loop A . Pull the free end of the waist belt B . • To tighten the shoulder belts: Hold the adjuster and pull the front shoulder strap down C .
PAGE 7
Tray Use and Care Uso y mantenimiento de la bandeja • Before first time use, wash the tray thoroughly with soap and water. • The tray is top rack dishwasher safe (or use the bottom rack - without using the drying cycle). • Antes de usar el producto por primera vez, lavar la bandeja con agua y jabón. • La bandeja se puede lavar en la parte de arriba de la lavaplatos (o en la parte de abajo, sin usar el ciclo de secado).
PAGE 8
Pad and Restraint System Care Mantenimiento del colchón y sistema de sujeción • The pad and restraint system are machine washable. Place the restraint system in a pillowcase and machine wash it along with the pad in cold water on the gentle cycle. Do not use bleach. Line dry. • To remove the pad and restraint system: Buckle the restraint system. From behind the seat and underneath the seat, push the folded end of each restraint belt back through the slots.
PAGE 9
Convert to Booster Seat Convertir en silla de aprendizaje This seat easily converts to a booster seat for toddlers. Esta silla se convierte fácilmente en silla de aprendizaje para niños pequeños. Shoulder Belts Cinturones de los hombros 1 3 • Unbuckle the waist belts from the crotch belt. • Pull to remove the waist belts from the end of each shoulder belt. • Fit the shoulder belts back through the slots in the pad. • Remove the pad from the seat. • Retirar la almohadilla de la silla.
PAGE 10
Parts Piezas Assembly Montaje Base Base Tray Bandeja C Cross B Brace Barra transversal Base Base Pad Almohadilla 1 Seat Bottom Asiento • Turn the seat bottom over. • Fit the bases onto the seat bottom. Hint: Each base is designed to fit on the seat bottom one way. • Insert two screws into each base and tighten. Seat Back with Restraint System Respaldo con sistema de sujeción • Voltear el asiento. • Ajustar las bases en el asiento.
PAGE 11
Assembly Montaje • Ajustar los extremos del respaldo en las ranuras de la parte de arriba del asiento. • Empujar la parte de arriba del respaldo de modo que la lengüeta del medio se ajuste en su lugar. 3 PULL JALAR • Turn the seat bottom assembly upright. • As received, the seat bottom is in the recline position. To finish the assembly of this product, adjust the seat to the upright position. • While pulling the seat recline handle on the back of the seat, lift the seat back to the upright position.
PAGE 12
Assembly Montaje Hooks Ganchos 8 Upper Slots Ranuras superiores • Fasten the hooks on bottom of the pad to the front edge of the seat. • Ajustar los ganchos de la parte de abajo de la almohadilla en el borde delantero de la silla. 7 Lower Slots Ranuras inferiores • Insert the shoulder belts through the slots in the pad. - Use the lower shoulder belt slots for a smaller baby. - Use the upper shoulder belt slots for a larger baby. Remove the shoulder belts from the lower slots in the seat back.