Riding Toy User Manual

10
J4390pr-0922
• Fit a mirror and mirror cover to an end of the dash assembly.
• Insert two #8 x
3
/4" screws into the mirror cover and tighten.
• Repeat this procedure to attached the other mirror and mirror
cover to the opposite end of the dash assembly.
Mirror
9
E
• Insert six #8 x
3
/4" screws into the front bumper and tighten.
8
• Fit a
3
/8"-16 lock nut, rounded side out, onto the front axle.
IMPORTANT! Tighten the lock nut firmly with the closed end of
the assembly tool.
• Repeat steps 4-6 to assemble the other washer, bushing, front
wheel and wheel cover with the remaining
3
/8"-16 lock nut.
Lock Nut
6
• Align the slot in a hubcap with the rib in the wheel cover.
“Snap” a hubcap into the center of each wheel cover.
• Turn the vehicle upright.
7
Hubcaps
Hubcaps
Mirror Cover
Dash Assembly
Assembly
Tool
ASSEMBLY
FRONT VIEW