N1366 Please keep this instruction sheet for future reference, as it contains important information. Adult assembly is required. Tools required for assembly: Phillips Screwdriver, Hammer and Scrap Block of Wood (not included). Requires three "AA" batteries (included). Age: 2-6 years. Weight limit: 60 lbs (27 kg). www.fisher-price.
Consumer Information WARNING CAUTION To avoid serious injury: • Adult supervision is required. • Never use near cars and other motor vehicles, near streets, steps, sloped driveways, hills, roadways, alleys, swimming pool areas or other bodies of water. • Always wear shoes or sneakers. • Never allow more than one rider. This product contains small parts in its unassembled state. Adult assembly is required.
Assembly Rear Wheel (Indented Side Up) Cap Nut Hubcap (Peg Side Down) Cover Straight Axle Frame Hubcap Rear Wheel (Indented Side Down) Hubcap (Peg Side Up) Assembled Rear Wheel Straight Axle 1 3 Cap Nut Assembly Tool • Turn the frame on its side with the exposed end of the straight axle up. • Place the cap nut assembly tool under the assembled rear wheel and onto the cap nut. • Slide a rear wheel (indented side up) onto the end of the straight axle.
Assembly Pedal Hubs Pedal Pedal Axle Front Wheel Pedal Axle Hole 5 Scrap Block of Wood • While holding the pedal hubs on the pedal axle, insert the pedal axle through the hole in the center of the front wheel. • Push the pedal hubs into the center of the front wheel until they are flush with the surface of the front wheel. 7 • Fit the pedal on the pedal axle. Tap the pedal with a hammer until it is secure. • Pull the pedal up to be sure it is secure.
Assembly Slot Handlebar Headlight Cover Frame Neck Fork Post Fork Cover Rear of Trike 9 11 • Fit the tab on the headlight cover to the slot in the top of the handlebar. • Insert two #6 x 1/2" screws into the headlight cover. Tighten the screws. • Insert the fork post up through the hole in the neck of the frame. Make sure the fork is positioned so that the fork covers face the rear wheels. • Place the handlebar onto the fork post and push it down onto the frame.
Label Decoration 13 12 Attaching the Seat Hint: The seat can be attached to the frame in any of three positions, depending on the size of your child. Check your child’s fit on the trike by observing the seat to pedal distance, as it is being ridden. If the pedals seem too far away or too close for your child, move the seat up or down.
Battery Replacement Battery Safety Information For best performance, we recommend replacing the batteries that came with this trike with three, new alkaline "AA" (LR6) batteries. In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage: • Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
Removing the Seat Consumer Information Seat Seat Retainer Tab Frame Seat Retainer Tab • Turn the frame on its side. • Squeeze the seat retainer tabs toward one another and lift the seat from the frame. Let's Go! Weather Music Places to Go Ignition Sounds Power Switch Turn Signal Turn Signal Horn • • • • Slide the power switch ON. Turn the ignition, “VRROOOM!” Press the left or right turn signals for flashing blinkers.