P4259 www.fisher-price.
Consumer Information WARNING CAUTION Prevent serious injury or death from falls or sliding out. • The child should be secured in the high chair at all times by the restraint system, either in the reclining or upright position. The restraint belts must be adjusted to fit your child snugly. The tray is not designed to hold the child in the chair. • It is recommended that only children capable of sitting upright unassisted use the high chair in the upright position.
Parts Footrest Food Tray Snack Tray Seat Back with Shoulder and Waist Belts 2 Front Legs 2 Back Legs Seat Bottom with Crotch Belt 2 Seat Brackets Back Base Front Base M4 x 17mm Screw – 6 Seat Pad M5 x 60mm Screw – 6 All Fasteners Shown Actual Size Tighten the screws with the enclosed Allen wrench.
Assembly IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Fisher-Price® for replacement parts and instructions if needed. Never substitute parts. Back Leg Back Leg Seat Bottom Large Socket 3 1 • Fit the other back leg into the large socket in the seat bottom. • Turn the seat bottom upside down on a flat surface.
Assembly Front Leg Front Leg Seat Bottom Small Socket 5 7 • Position a front leg so that it curves up and fit it into the small socket in the seat bottom. Hint: If the leg does not seem to fit into the seat bottom, try the other front leg. • Fit the other front leg into the small socket in the seat bottom. M5 x 60mm Screws M5 x 60mm Screws 8 • Insert two M5 x 60mm screws into the side of the seat bottom and tighten.
Assembly Back Base Back Legs Posts M6 x 28mm Screws M6 x 28mm Screws Footrest 11 • Fit the sockets on the footrest onto the posts on the front of the assembly. • Slide the footrest up onto the posts. Hint: You may want to lower the seat to assemble the footrest. Refer to page 13 for instructions to lower the seat. 9 • Fit the back base onto the bottom of both back legs, as shown. • Insert two M6 x 28mm screws into each back leg and tighten.
Assembly Seat Back M4 x 17mm Screws Peg Holes 15 13 • Insert two M4 x 17mm screws into the seat back and tighten. • At an angle, fit the pegs on each side of the seat back into the holes in the sides of the seat bottom. Hint: You may need to flex the bottom edge of the seat back to fit the seat back pegs into the holes in the seat bottom. Seat Bracket M4 x 17mm Screws 16 14 • Fit a seat bracket to the side of the seat bottom, as shown. • Insert two M4 x 17 mm screws and tighten.
Assembly Slots Seat Bracket Shoulder Belt M4 x 17mm Screws Shoulder Belt 19 17 • Fit the other seat bracket to the other side of the seat bottom, as shown. • Insert two M4 x 17 mm screws and tighten. Hint: The shoulder belts come assembled to the seat back in the lower position for a smaller child. To change to the upper slots for a larger child, refer to page 12. • Place the seat pad onto the seat. • Pull the shoulder belts ends through the slots in the seat pad.
Assembly Shoulder Belts Elastic Loops Slots 21 23 • Fit the elastic loops on the seat pad down through the slots in the footrest. • Fit the ends of the waist belts through the clips on the shoulder belts. 24 Pegs 22 BACK VIEW • Fit the upper pocket of the seat pad onto the seat back. • Fit the elastic loops on the seat pad bottom onto the pegs on the footrest.
Securing Your Child WARNING Prevent serious injury or death from falls or sliding out. • The child should be secured in the high chair at all times by the restraint system, either in the reclining or upright position. The restraint belts must be adjusted to fit your child snugly. The tray is not designed to hold the child in the chair. • It is recommended that only children capable of sitting upright unassisted use the high chair in the upright position.
Securing Your Child Adjuster Adjuster TIGHTEN 2 • Tighten each waist belt/shoulder belt so that the restraint system is snug against your child. Please refer to the next section for instructions to tighten the waist belts/shoulder belts. 3 LOOSEN • To tighten the waist belts: Feed the anchored end of the waist belt up through the buckle to form a loop A. Pull the free end of the waist belt B. • To tighten the shoulder belts: Hold the adjuster and pull the shoulder belt down C.
Securing Your Child Shoulder Belts Upper Slots Restraint System 4 6 • Unbuckle the restraint system. Larger Baby • Insert the ends of the shoulder belts through the upper slots in the pad and seat back. Shoulder Belts Lower Slots Shoulder Belts 5 7 • To adjust the restraint height for baby, push to remove the shoulder belts from the seat back. Smaller Baby • Insert the ends of the shoulder belts through the lower slots in the pad and seat back.
Seat Adjustment PULL PULL Seat Back Latch 1 2 Adjusting Seat Height • Pull the levers on both seat height adjusters and lift or lower the seat to any of five different heights. • Make sure both sides of the seat are adjusted to the same height. • Push the seat bottom to be sure the seat is secure. Adjusting Seat Recline Hint: Adjust the seat angle to any of three positions: Upright, Semi-Recline or Recline.
Using the Trays Hint: Before use, thoroughly wash all parts (the trays) that may contact food. The snack tray is not dishwasher safe. The snack and food trays are not microwave safe. Armrests Snack Tray 3 1 • While pulling the release tabs on the sides of the food tray, adjust the tray forward or backward. • While pulling the release handles on the sides of the food tray, lift to remove it. • Slide the snack tray onto the seat armrests. Push the snack tray until it "snaps" into place.
Storage Care • The snack tray, seat and restraint straps may be wiped clean using a mild cleaning solution and damp cloth. Do not use bleach. Do not use harsh or abrasive cleansers. Rinse clean with water to remove residue. • The food tray is dishwasher safe. • Machine wash the seat pad in cold water with a mild detergent. Do not use bleach. Tumble dry on low heat and remove promptly. • To remove the pad: - Push to remove the shoulder belts, waist belts and crotch belt from the seat and pads.
CANADA Mattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2. Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, New York 14052, U.S.A. ©2009 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
