User Manual

2
Wheel Hub
(Flat Side Down)
Bushing
(Grooved Side Down)
Straight
Axle
Rear
Wheel
(Indented
Side Down)
Parts Assembly
• Place one end of the straight axle into a .354" (0,9 cm) cap nut.
Tap the end of the straight axle with a hammer. Pull on the cap
nut to be sure it is securely attached to the straight axle.
• Slide a wheel hub,  at side down, onto the straight axle.
• Slide a rear wheel, indented side down, onto the straight axle.
• Slide a bushing, grooved side down, onto the straight axle.
• Fit the seat onto the frame. Push  rmly near the back end of the
seat to "snap" it into place.
Frame
Seat
PUSH
Straight
Axle
.354" (0,9 cm)
Cap Nut
• Tighten assembled screws with a Phillips screwdriver. Do not
over-tighten the screws.
• Please save all packaging material until assembly is complete to
ensure that no parts are discarded. Wipe each part with a clean,
dry cloth before assembly.
• Label sheet is not shown.
1
2
#8 x 2¼" (5,7 cm) Screw - 1
FASTENERS SHOWN ACTUAL SIZE
*We’ve included one extra
.354" (0,9 cm) cap nut for
your convenience.
#8 x ¾" (1,9 cm) Screw - 6.354" (0,9 cm) Cap Nut - 2*
.354"
CAUTION
This product contains small parts in its
unassembled state. Adult assembly is required.
Handlebar Front
Frame
Handlebar Back
Seat
Straight Axle
2 Bushings
2 Wheel Hubs
2 Wheel Caps
2 Rear Wheels
4 Pedal Hubs
Fork
2 Fork Covers
Front Wheel Assembly