Manual

6
SETTING UP
semicircle around the front of the operator.
4. Hand tighten the lock nut and search coil
adjusting wing nut.
5. With the stem length properly adjusted, wrap
the search coil cable snugly around the upper
handle and secure it with velcro straps. Leave
just enough slack near the coil to allow it to be
tilted completely backward and forward.
NOTE: A loose cable near the search coil may
cause false signals, but don’t wrap it so tightly
that it pulls against the housing or the coil.
6. Reconnect the search coil cable to the control
housing. Be careful not to cross thread it and
make sure it’s snug but hand tighten only.
7. With the shaft length and coil angle properly
adjusted, lean forward slightly and raise your arm
until the coil is about 2" above (and parallel to)
the ground, 6-12 inches in front of your foot.
8. If you’re using headphones, plug into the
headphone jack on the control panel.
Figure 3. Search position