Manual

TURN-ON-AND-GO ‘PRESET’ OPERATION

Your CZ-7a Pro Quicksilver is fairly simple to operate, especially

when compared to other target-I. D. machines. Even so, we

strongly recommend that you read this entire manual. You'll be

able to tune your CZ-7a Pro to your specific needs and ground

conditions. And if you have a good understanding of how to

ground balance and why, you'll find more.

But if you just can't wait any longer, and you're an

experienced detector user, here's some quick instructions to

get you going:

1. If using optional headphones: Plug your

headphones into the jack on the control panel

and put them around your neck.

2. Turn the power on by rotating the the

GROUND BALANCE knob clockwise to the red 5.

3. Press and release the PRESET touch pad.

4. Your CZ-7a Pro is now in a "coins-only" mode,

preset at the factory to accept U.S. coins and

reject small ferrous and aluminum trash.

5. You are ready to begin your search at this

point, but first, if using optional headphones, put

them on and pass the coil over a large target. If

the response is too loud or not loud enough,

adjust the volume by pressing and releasing the

VOL touch pad and pressing the left/right arrows

touch pads. Press and release the SEARCH/

PINPOINT pad to exit the Volume function and

activate the Search mode.

6. As you begin your search, keep in mind that

the GROUND BALANCE setting of 5 may not be

To use the turn-on-and-go

feature of your CZ-7a Pro,

turn the GROUND BALANCE

knob to the red 5 preset

mark and touch and hold

the PRESET touch pad.