Manual

BATTERY REPLACEMENT

Three battery markers showing on the LCD indicate fully

charged, or nearly fully charged batteries. Two markers mean

that the batteries have been used for several hours but are still

well within operating range. One or no markers mean that it's

time for new batteries. Two 9-volt transistor batteries are

located in separate compartments on the underside of the

control housing.

1. Remove the control housing from the

handle grip by holding the grip in one

hand and sliding the control housing

toward you.

2. Remove the battery doors by gently lifting the

two tabs at the end of the control housing.

3. Remove the batteries by pulling on the nylon

straps attached to the bottom of the battery

compartments.

4. Install fresh alkaline batteries and reinstall the

battery covers. Make sure the batteries are

positioned properly as indicated by the "+"

polarity markings inside the battery

compartments.

If either or both of the batteries are installed

incorrectly, the CZ-7a Pro will simply not turn on.

The detector will not be damaged.

LOW OK BATTERY